CISCO-HSRP-EXT-MIB Download
The Extension MIB module for the CISCO-HSRP-MIB which is
based on RFC2281.
This MIB provides an extension to the CISCO-HSRP-MIB which
defines Cisco's proprietary Hot Standby Routing Protocol
(HSRP), defined in RFC2281. The extensions cover assigning
of secondary HSRP ip addresses, modifying an HSRP Group's
priority by tracking the operational status of interfaces,
etc.
IPHost Network Monitor offer an easy way of SNMP monitoring your Cisco Servers, Routers, Switches, Bridges,
Firewalls, Repeaters.
OID list for CISCO-HSRP-EXT-MIB
- cHsrpExtIfTrackedTable
- A table containing information about tracked interfaces per HSRP group.
- cHsrpExtIfTrackedEntry
- Each row of this table allows the tracking of one interface of the HSRP group which is identified by the (ifIndex, cHsrpGrpNumber) values in this table's INDEX clause. Weight(priority) is given to each and every interface tracked. When a tracked interface ...
- cHsrpExtIfTracked
- The ifIndex value of the tracked interface.
- cHsrpExtIfTrackedPriority
- Priority of the tracked interface for the corresponding { ifIndex, cHsrpGrpNumber } pair. In the range of 0 to 255, 0 is the lowest priority and 255 is the highest. When a tracked interface is unavailable, the cHsrpGrpPriority of the router is decreased b ...
- cHsrpExtIfTrackedRowStatus
- The control that allows modification, creation, and deletion of entries. For detailed rules see the DESCRIPTION for cHsrpExtIfTrackedEntry.
- cHsrpExtIfTrackedIpNone
- This object specifies the disable HSRP IPv4 virtual IP address.
- cHsrpExtSecAddrTable
- A table containing information about secondary HSRP IP Addresses per interface and group.
- cHsrpExtSecAddrEntry
- The CHsrpExtSecAddrEntry allows creation of secondary IP Addresses for each cHsrpGrpEntry row. Secondary addresses can be added by setting cHsrpExtSecAddrRowStatus to be active. The value of cHsrpExtSecAddrRowStatus may be set to destroy at any time. Entr ...
- cHsrpExtSecAddrAddress
- A secondary IpAddress for the {ifIndex, cHsrpGrpNumber} pair. As explained in the DESCRIPTION for cHsrpExtSecAddrEntry, a primary address must exist before a secondary address for the same {ifIndex, cHsrpGrpNumber} pair can be created.
- cHsrpExtSecAddrRowStatus
- The control that allows modification, creation, and deletion of entries. For detailed rules see the DESCRIPTION for cHsrpExtSecAddrEntry.
- cHsrpExtIfStandbyTable
- A table containing information about standby interfaces per HSRP group.
- cHsrpExtIfStandbyEntry
- The cHsrpExtIfStandbyEntry allows an HSRP group interface to track one or more standby interfaces. To create a new cHsrpExtIfStandbyEntry row, a management station should choose the ifIndex of the interface which is to be added as part of an HSRP group. A ...
- cHsrpExtIfStandbyIndex
- This object defines the index of the standby table.
- cHsrpExtIfStandbyDestAddrType
- This object specifies the type of Internet address denoted by cHsrpExtIfStandbyDestAddr.
- cHsrpExtIfStandbyDestAddr
- This object specifies the destination IP address of the standby router.
- cHsrpExtIfStandbySourceAddrType
- This object specifies the type of Internet address denoted by cHsrpExtIfStandbySourceAddr.
- cHsrpExtIfStandbySourceAddr
- This object specifies the source IP address of the standby router.
- cHsrpExtIfStandbyRowStatus
- The control that allows modification, creation, and deletion of entries. Entries may not be created via SNMP without explicitly setting cHsrpExtIfStandbyRowStatus to either 'createAndGo' or 'createAndWait'.
- cHsrpExtIfTable
- HSRP-specific configurations for each physical interface.
- cHsrpExtIfEntry
- If HSRP entries on this interface must use the BIA (Burned In Address), there must be an entry for the interface in this table. Entries of this table are only accessible if HSRP has been enabled i.e entries can not be created if HSRP is not enabled. Also, ...
- cHsrpExtIfUseBIA
- If set to TRUE, the HSRP Group MAC Address for all groups on this interface will be the burned-in-address. Otherwise, this will be determined by ciscoHsrpGroupNumber. In case of sub-interfaces, UseBIA applies to all sub-interfaces on an interface and to ...
- cHsrpExtIfRowStatus
- The control that allows modification, creation, and deletion of entries. For detailed rules see the DESCRIPTION for cHsrpExtIfEntry.
- cHsrpExtIfTrackedGroup
- The collection of objects used to add, delete and retrieve the interfaces getting tracked for HSRP groups.
- cHsrpExtSecAddrGroup
- The collection of objects used to add, delete and retrieve primary and secondary Ip Addresses for HSRP groups.
- cHsrpExtIfGroup
- Object which tells if HSRP entries on this interface must use BIA or not.
- cHsrpExtIfStandbyGroup91
- The collection of objects used to add, delete and retrieve the interfaces getting standby for HSRP groups.
- cHsrpExtIfTrackedGroupSup1
- The collection of HSRP interface tracked objects which suppliments cHsrpExtIfTrackedGroup.
Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring network devices right now.
