With IPHost Network Monitor you can run simple snmp requests against a HP device in your network.
postscript-resource-saving-memory-size
postscript-resource-saving-memory-size
1.3.6.1.4.1.11.2.3.9.4.2.1.3.3.4.2
Returns or changes the amount of resource saving memory set aside to hold permanent soft PostScript resources. Additional information: The value returned by this object is the amount of Resource Saving memory currently dedicated to PostScript, regardless of the value of RESOURCE-SAVING. If PostScript is installed, the default value of this object is as follows: 0 if RESOURCE-SAVING=eOff. 0 if <12M memory is installed. 400K if >=12M memory is installed and RESOURCE-SAVING=eOn. 400K if =12M memory is installed and RESOURCE-SAVING=eAuto. plus 100K for each 1M over 12M memory installed. If RESOURCE-SAVING=eOn, this object can be used to set the amount of Resource Saving memory currently dedicated to PostScript. The range of values supported by this object are: 0 (disables resource saving for PostScript). 400K bytes through (400K bytes + value of MAXIMUM-RESOURCE-SAVING-MEMORY) in increments of 100K bytes. If a value is received that is greater than 0 and less than 400K bytes, it will be snapped to 400K bytes and a status of will be returned. If an unsupported value greater than 400K bytes is received, it will be snapped down to the nearest 100K value and a status of will be returned. Attempting to set this object when RESOURCE-SAVING is eAuto or eOff will cause a status of to be returned.
Back to 2100_snmp MIB page.
IPHost Network monitor allows you to monitor postscript-resource-saving-memory-size on Hewlett Packard device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco wireless switches right now.