CISCO-MGX82XX-RPM-SUBIF-MIB Download
This MIB is used to provision backplane sub-interfaces
on the MGX's Route Processor Module (RPM). This MIB is
implemented on the MGX controller to manage the RPM. The RPM
family of Router Modules run the IOS Operating System
IPHost Network Monitor offer an easy way of SNMP monitoring your Cisco Servers, Routers, Switches, Bridges,
Firewalls, Repeaters.
OID list for CISCO-MGX82XX-RPM-SUBIF-MIB
- rpmPortTable
- This table contains information on subinterfaces configured on RPM back plane interface.
- rpmPortEntry
- An entry for the RPM backplane sub interface. Each entry contains RPM's backplane sub interface number, its IP address and ATM address.
- rpmPortSlotNum
- This object specifies the the slot number of the RPM card in MGX shelf.
- rpmPortInterface
- This is the RPM's backplane interface. Currently there is only one interface and hence only supported value is 1.
- rpmPortSubInterface
- This object identifies the sub-interface number. The value 0 is for the sub-interface on the main interface(rpmPortInterface).
- rpmPortRowStatus
- This indicates the status of this subinterface. add(1) : sub-interface is added. del(2) : sub-interface is deleted. mod(3) : Set to this value before modifying objects related to Subinterfaces.
- rpmPortIpAddress
- IP address configured on the sub-interface.
- rpmPortSubNetMask
- The subnet mask configured on the sub-interface.
- rpmPortState
- This indicates the state of this sub-interface. notConfigured(1) : Sub-interface is not configured. active(2) : Sub-interface is in active state. failed(3) : Sub-interface is in failed state.
- cmrSubIfMIBGroup
- Objects related to ATM Subinterface in RPM module.
Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring network devices right now.
