PIM-MIB Download

pimJoinPruneInterval

The default interval at which periodic PIM-SM Join/Prune messages are to be sent.

pimInterfaceTable

The (conceptual) table listing the router's PIM interfaces. IGMP and PIM are enabled on all interfaces listed in this table.

pimInterfaceEntry

An entry (conceptual row) in the pimInterfaceTable.

pimInterfaceIfIndex

The ifIndex value of this PIM interface.

pimInterfaceAddress

The IP address of the PIM interface.

pimInterfaceNetMask

The network mask for the IP address of the PIM interface.

pimInterfaceMode

The configured mode of this PIM interface. A value of sparseDense is only valid for PIMv1.

pimInterfaceDR

The Designated Router on this PIM interface. For point-to- point interfaces, this object has the value 0.0.0.0.

pimInterfaceHelloInterval

The frequency at which PIM Hello messages are transmitted on this interface.

pimInterfaceStatus

The status of this entry. Creating the entry enables PIM on the interface; destroying the entry disables PIM on the interface.

pimInterfaceJoinPruneInterval

The frequency at which PIM Join/Prune messages are transmitted on this PIM interface. The default value of this object is the pimJoinPruneInterval.

pimInterfaceCBSRPreference

The preference value for the local interface as a candidate bootstrap router. The value of -1 is used to indicate that the local interface is not a candidate BSR interface.

pimNeighborTable

The (conceptual) table listing the router's PIM neighbors.

pimNeighborEntry

An entry (conceptual row) in the pimNeighborTable.

pimNeighborAddress

The IP address of the PIM neighbor for which this entry contains information.

pimNeighborIfIndex

The value of ifIndex for the interface used to reach this PIM neighbor.

pimNeighborUpTime

The time since this PIM neighbor (last) became a neighbor of the local router.

pimNeighborExpiryTime

The minimum time remaining before this PIM neighbor will be aged out.

pimNeighborMode

The active PIM mode of this neighbor. This object is deprecated for PIMv2 routers since all neighbors on the interface must be either dense or sparse as determined by the protocol running on the interface.

pimIpMRouteTable

The (conceptual) table listing PIM-specific information on a subset of the rows of the ipMRouteTable defined in the IP Multicast MIB.

pimIpMRouteEntry

An entry (conceptual row) in the pimIpMRouteTable. There is one entry per entry in the ipMRouteTable whose incoming interface is running PIM.

pimIpMRouteUpstreamAssertTimer

The time remaining before the router changes its upstream neighbor back to its RPF neighbor. This timer is called the Assert timer in the PIM Sparse and Dense mode specification. A value of 0 indicates that no Assert has changed the upstream neighbor awa ...

pimIpMRouteAssertMetric

The metric advertised by the assert winner on the upstream interface, or 0 if no such assert is in received.

pimIpMRouteAssertMetricPref

The preference advertised by the assert winner on the upstream interface, or 0 if no such assert is in effect.

pimIpMRouteAssertRPTBit

The value of the RPT-bit advertised by the assert winner on the upstream interface, or false if no such assert is in effect.

pimIpMRouteFlags

This object describes PIM-specific flags related to a multicast state entry. See the PIM Sparse Mode specification for the meaning of the RPT and SPT bits.

pimIpMRouteNextHopTable

The (conceptual) table listing PIM-specific information on a subset of the rows of the ipMRouteNextHopTable defined in the IP Multicast MIB.

pimIpMRouteNextHopEntry

An entry (conceptual row) in the pimIpMRouteNextHopTable. There is one entry per entry in the ipMRouteNextHopTable whose interface is running PIM and whose ipMRouteNextHopState is pruned(1).

pimIpMRouteNextHopPruneReason

This object indicates why the downstream interface was pruned, whether in response to a PIM prune message or due to PIM Assert processing.

pimRPTable

The (conceptual) table listing PIM version 1 information for the Rendezvous Points (RPs) for IP multicast groups. This table is deprecated since its function is replaced by the pimRPSetTable for PIM version 2.

pimRPEntry

An entry (conceptual row) in the pimRPTable. There is one entry per RP address for each IP multicast group.

pimRPGroupAddress

The IP multicast group address for which this entry contains information about an RP.

pimRPAddress

The unicast address of the RP.

pimRPState

The state of the RP.

pimRPStateTimer

The minimum time remaining before the next state change. When pimRPState is up, this is the minimum time which must expire until it can be declared down. When pimRPState is down, this is the time until it will be declared up (in order to retry).

pimRPLastChange

The value of sysUpTime at the time when the corresponding instance of pimRPState last changed its value.

pimRPRowStatus

The status of this row, by which new entries may be created, or old entries deleted from this table.

pimRPSetTable

The (conceptual) table listing PIM information for candidate Rendezvous Points (RPs) for IP multicast groups. When the local router is the BSR, this information is obtained from received Candidate-RP-Advertisements. When the local router is not the BSR, ...

pimRPSetEntry

An entry (conceptual row) in the pimRPSetTable.

pimRPSetGroupAddress

The IP multicast group address which, when combined with pimRPSetGroupMask, gives the group prefix for which this entry contains information about the Candidate-RP.

pimRPSetGroupMask

The multicast group address mask which, when combined with pimRPSetGroupAddress, gives the group prefix for which this entry contains information about the Candidate-RP.

pimRPSetAddress

The IP address of the Candidate-RP.

pimRPSetHoldTime

The holdtime of a Candidate-RP. If the local router is not the BSR, this value is 0.

pimRPSetExpiryTime

The minimum time remaining before the Candidate-RP will be declared down. If the local router is not the BSR, this value is 0.

pimRPSetComponent

A number uniquely identifying the component. Each protocol instance connected to a separate domain should have a different index value.

pimCandidateRPTable

The (conceptual) table listing the IP multicast groups for which the local router is to advertise itself as a Candidate-RP when the value of pimComponentCRPHoldTime is non-zero. If this table is empty, then the local router will advertise itself as a Can ...

pimCandidateRPEntry

An entry (conceptual row) in the pimCandidateRPTable.

pimCandidateRPGroupAddress

The IP multicast group address which, when combined with pimCandidateRPGroupMask, identifies a group prefix for which the local router will advertise itself as a Candidate-RP.

pimCandidateRPGroupMask

The multicast group address mask which, when combined with pimCandidateRPGroupMask, identifies a group prefix for which the local router will advertise itself as a Candidate-RP.

pimCandidateRPAddress

The (unicast) address of the interface which will be advertised as a Candidate-RP.

pimCandidateRPRowStatus

The status of this row, by which new entries may be created, or old entries deleted from this table.

pimComponentTable

The (conceptual) table containing objects specific to a PIM domain. One row exists for each domain to which the router is connected. A PIM-SM domain is defined as an area of the network over which Bootstrap messages are forwarded. Typically, a PIM-SM ro ...

pimComponentEntry

An entry (conceptual row) in the pimComponentTable.

pimComponentIndex

A number uniquely identifying the component. Each protocol instance connected to a separate domain should have a different index value. Routers that only support membership in a single PIM-SM domain should use a pimComponentIndex value of 1.

pimComponentBSRAddress

The IP address of the bootstrap router (BSR) for the local PIM region.

pimComponentBSRExpiryTime

The minimum time remaining before the bootstrap router in the local domain will be declared down. For candidate BSRs, this is the time until the component sends an RP-Set message. For other routers, this is the time until it may accept an RP-Set message ...

pimComponentCRPHoldTime

The holdtime of the component when it is a candidate RP in the local domain. The value of 0 is used to indicate that the local system is not a Candidate-RP.

pimComponentStatus

The status of this entry. Creating the entry creates another protocol instance; destroying the entry disables a protocol instance.

pimV2MIBGroup

A collection of objects to support management of PIM Sparse Mode (version 2) routers.

pimDenseV2MIBGroup

A collection of objects to support management of PIM Dense Mode (version 2) routers.

pimV2CandidateRPMIBGroup

A collection of objects to support configuration of which groups a router is to advertise itself as a Candidate-RP.

pimV1MIBGroup

A collection of objects to support management of PIM (version 1) routers.

pimNextHopGroup

A collection of optional objects to provide per-next hop information for diagnostic purposes. Supporting this group may add a large number of instances to a tree walk, but the information in this group can be extremely useful in tracking down multicast c ...

pimAssertGroup

A collection of optional objects to provide extra information about the assert election process. There is no protocol reason to keep such information, but some implementations may already keep this information and make it available. These objects can al ...