hpprocurve-v2-hprptr Download

hpRptrEntityName

********* THIS OBJECT IS DEPRECATED ********* The local name of this repeater. This is the same value as hpicfEntityName in the case where there is Distributed Management Protocol to access this device. For SNMPv1, this name is appended to the agent comm ...

hpRptrThinlanFault

********* THIS OBJECT IS DEPRECATED ********* When set to 'true' this object causes the Fault Led to blink if the ThinLan Port is segmented. This object has been deprecated. It only makes sense in systems that support a single BNC port.

hpRptrSqeEnabled

********* THIS OBJECT IS DEPRECATED ********* When 'true', this flag indicates that SQE has been detected for the last ten agent transmits and there is a high probability that the SQE switch on the transceiver attached to the AUI port is set to Enabled, w ...

hpRptrRobustHealing

********* THIS OBJECT IS DEPRECATED ********* When this flag is set to 'true', it enables robust port healing mode. The 802.3 specification states that a segmented port is healed by successfully transmitting or receiving a packet on the port. This mode ...

hpRptrBasicGroupTable

********* THIS OBJECT IS DEPRECATED ********* HP specific extensions to the rptrGroupTable.

hpRptrBasicGroupEntry

********* THIS OBJECT IS DEPRECATED ********* An entry in the table, containing HP extensions for a specific group.

hpRptrGrpGroupIndex

********* THIS OBJECT IS DEPRECATED ********* The group within the repeater for which this entry contains information. This object has the same value as the corresponding instance of rptrGroupIndex.

hpRptrGrpPortsAdminStatus

********* THIS OBJECT IS DEPRECATED ********* The hpRptrGrpPortsAdminStatus is a bit map of the state of the rptrPortAdminStatus object for all of the ports in this group. The object has a one bit for each port for which the value of rptrPortAdminStatus ...

hpRptrGrpPortsSegStatus

********* THIS OBJECT IS DEPRECATED ********* The hpRptrGrpPortsSegStatus is a bit map of the state of the rptrPortAutoPartitionState of all of the ports in this group. The object has a one bit for each port for which the value of rptrPortAutoPartitionS ...

hpRptrGrpPortsMediaAvailable

********* THIS OBJECT IS DEPRECATED ********* The hpRptrGrpPortsMediaAvailable is a bit map of the state of the rpMauMediaAvailable object for all of the ports in this group. The object has a one bit for each port for which the value of rpMauMediaAvailab ...

hpRptrGrpPortsLinkbeatEnabled

********* THIS OBJECT IS DEPRECATED ********* The hpRptrGrpPortsLinkbeatEnabled is a bit map of the state of the hpRptrPtLinkbeatEnable object for all of the ports in this group. The object has a one bit for each port for which the value of hpRptrPtLink ...

hpRptrGrpPortsOperStatus

********* THIS OBJECT IS DEPRECATED ********* The hpRptrGrpPortsOperStatus is a bit map of the state of all hub ports in the group. The object has a 1 bit for each port that is enabled, not segmented, and the media is available. Ports on which these con ...

hpRptrBasicPtTable

HP specific extensions to the rptrPortTable.

hpRptrBasicPtEntry

An entry in the table, containing HP extensions for a specific port.

hpRptrPtGroupIndex

The group containing the port for which this entry contains information. This object has the same value as the corresponding instance of rptrPortGroupIndex.

hpRptrPtPortIndex

The port within the group for which this entry contains information. This object has the same value as the corresponding instance of rptrPortIndex.

hpRptrPtLinkbeatEnable

When this flag is set to 'true' the port's link beat is enabled and when set to 'false' it is disabled.

hpRptrPtPolarityReversed

This object is used to indicate that the hub port was wired with the positive/negative polarity of its transmit and receive pairs reversed. Note that the port will continue to operate in this state, with the hub inverting the polarity internally.

hpRptrPtSqeEnabled

When 'true', this flag indicates that SQE has been detected for the last ten agent transmits and there is a high probability that the SQE switch on the transceiver attached to this port is set to Enabled, when it should be Disabled. This value can only b ...

hpRptrPtMediaAvailTrapEnable

Indicates whether hpicfMediaAvailDetectTrap and hpicfMediaAvailLostTrap events should be generated for MAUs attached to this port. This object has the value of 'false' by default. Setting the value of this object to 'true' will cause a hpicfMediaAvailDe ...

hpRptrPtLongCableEnable

When this flag is set to 'true' the port's squelch level will be reduced to account for extended distance connections. When set to 'false', this port's squelch level will be normal. We recommend that this object only be set to 'true' for ports that are ...

hpRptrMonGlobalFrames

********* THIS OBJECT IS DEPRECATED ********* The total number of frames of valid frame length that have been received on all ports in this repeater. This counter is the summation of the values of the rptrMonitorPortReadableFrames counter for all of the ...

hpRptrMonGlobalOctets

********* THIS OBJECT IS DEPRECATED ********* The total number of octets contained in the valid frames that have been received on the ports in this repeater. This counter is the summation of the values of the rptrMonitorPortReadableOctets counter for all ...

hpRptrMonGlobalFCSErrors

********* THIS OBJECT IS DEPRECATED ********* This counter is incremented by one for each frame received on any port with the FCSError signal asserted and the FramingError and CollisionEvent signals deasserted and whose OctetCount is greater than or equal ...

hpRptrMonGlobalAlignmentErrors

********* THIS OBJECT IS DEPRECATED ********* This counter is incremented by one for each frame received on any port with the FCSError and FramingError signals asserted and CollisonEvent signal deasserted and whose OctetCount is greater than or equal to m ...

hpRptrMonGlobalFrameTooLongs

********* THIS OBJECT IS DEPRECATED ********* This counter is incremented by one for each frame received on any port whose OctetCount is greater than maxFrameSize (Ref: 4.4.2.1, IEEE 802.3 Std). If hpRptrMonGlobalFrameTooLongs is incremented, then neither ...

hpRptrMonGlobalShortEvents

********* THIS OBJECT IS DEPRECATED ********* This counter is incremented by one for each CarrierEvent on any port with ActivityDuration less than ShortEventMaxTime. ShortEventMaxTime is greater than 74 bit times and less than 82 bit times. ShortEventMa ...

hpRptrMonGlobalRunts

********* THIS OBJECT IS DEPRECATED ********* This counter is incremented by one for each CarrierEvent on any port that meets one of the following two conditions. Only one test need be made. a) The ActivityDuration is greater than ShortEventMaxTime and ...

hpRptrMonGlobalCollisions

********* THIS OBJECT IS DEPRECATED ********* This counter is incremented by one for any CarrierEvent signal on any port for which the CollisionEvent signal on any port is asserted. This counter differs from rptrMonitorTransmitCollisions in that it counts ...

hpRptrMonGlobalLateEvents

********* THIS OBJECT IS DEPRECATED ********* This counter is incremented by one for each CarrierEvent on any port in which the CollIn(X) variable transitions to the value SQE (Ref: 9.6.6.2, IEEE 802.3 Std) while the ActivityDuration is greater than the L ...

hpRptrMonGlobalVeryLongEvents

********* THIS OBJECT IS DEPRECATED ********* This counter is incremented by one for each CarrierEvent on any port whose ActivityDuration is greater than the MAU Jabber Lockup Protection timer TW3 (Ref: 9.6.1 & 9.6.5, IEEE 802.3 Std). Other counters may b ...

hpRptrMonGlobalDataRateMismatches

********* THIS OBJECT IS DEPRECATED ********* This counter is incremented by one for each frame received on any port that meets all of the following conditions: a) The CollisionEvent signal is not asserted. b) The ActivityDuration is greater than ValidP ...

hpRptrMonGlobalAutoPartitions

********* THIS OBJECT IS DEPRECATED ********* This counter is incremented by one for each time the repeater has automatically partitioned any port. The conditions that cause port partitioning are specified in the partition state machine in Section 9 of t ...

hpRptrMonGlobalErrors

********* THIS OBJECT IS DEPRECATED ********* The total number of errors which have occured on any port in this repeater. This counter is the summation of the values of other error counters, namely: hpRptrMonGlobalFCSErrors, hpRptrMonGlobalAlignmentError ...

hpRptrMonGlobalUcastPackets

********* THIS OBJECT IS DEPRECATED ********* This counter is incremented by one for each unicast packet of valid frame length received on any port. This counter is the summation of hpRptrMonPortUcastPackets for all of the ports in this repeater. This c ...

hpRptrMonGlobalBcastPackets

********* THIS OBJECT IS DEPRECATED ********* This counter is incremented by one for each broadcast packet of valid frame length received on any port. This counter is the summation of hpRptrMonPortBcastPackets for all of the ports in this repeater. This ...

hpRptrMonGlobalMcastPackets

********* THIS OBJECT IS DEPRECATED ********* This counter is incremented by one for each multicast packet of valid frame length received on any port. This counter is the summation of hpRptrMonPortMcastPackets for all of the ports in this repeater. This ...

hpRptrMonPtTable

Table of HP specific per port monitor objects.

hpRptrMonPtEntry

An entry in the table, containing per port objects for a single port.

hpRptrMonPtGroupIndex

The group containing the port for which this entry contains information. This object has the same value as the corresponding instance of rptrMonitorPortGroupIndex.

hpRptrMonPtPortIndex

The port within the group for which this entry contains information. This object has the same value as the corresponding instance of rptrMonitorPortIndex.

hpRptrMonPtUcastPackets

This counter is incremented by one for each unicast packet of valid frame length received on this port. This object may not be implemented for repeaters which do not have a local network management agent.

hpRptrMonPtBcastPackets

This counter is incremented by one for each broadcast packet of valid frame length received on this port. This object may not be implemented for repeaters which do not have a local network management agent.

hpRptrMonPtMcastPackets

This counter is incremented by one for each multicast packet of valid frame length received on this port. This object may not be implemented for repeaters which do not have a local network management agent.

hpRpMauTable

HP extensions to the rpMauTable.

hpRpMauEntry

An entry in the table, containing HP extensions for a single MAU.

hpRpMauTypeList

A value that uniquely identifies the set of possible IEEE 802.3 types that the MAU could be. If auto-negotiation is present on this MAU, this object will map to hpRpMauAutoNegCapability. Note that a repeater can never actually support the full-duplex MAU ...

hpRpMauAutoNegSupported

This object indicates whether or not auto-negotiation is supported on this MAU.

hpRpMauAutoNegAdminStatus

Setting this object to autoNegotiate(1) will cause auto-negotiation to be enabled on this port. Setting this object to forceTo100TXHD will cause auto-negotiation to be disabled on this port, and cause the operational type of the MAU on this port (as repor ...

hpRpMauAutoNegRemoteSignaling

A value indicating whether the remote end of the link is using auto-negotiation signaling. It takes the value detected(1) if and only if, during the previous link negotiation, FLP Bursts were received.

hpRpMauAutoNegConfig

A value indicating the current status of the auto-negotiation process. The enumeration parallelDetectFail(5) maps to a failure in parallel detection as defined in 28.2.3.1 of [IEEE 802.3 Std].

hpRpMauAutoNegCapReceived

A value that uniquely identifies the set of capabilities received from the remote auto-negotiation entity. Note that ports that support this MIB may be attached to remote auto-negotiation entities which have capabilities beyond the scope of this MIB.

hpRpMauAutoNegRestart

If the value of this object is set to restart(1) then this will force auto-negotiation to begin link renegotiation. If auto-negotiation signaling is disabled, a write to this object has no effect. Setting the value of this object to norestart(2) has no ef ...

hpicf8023RptrBasicGroup

********* THIS GROUP IS DEPRECATED ********* A collection of HP specific extensions to the 802.3 Repeater MIB for the HP AdvanceStack product line.

hpicf8023RptrBasicSlaveGroup

********* THIS GROUP IS DEPRECATED ********* A collection of HP specific extensions to the 802.3 Repeater MIB for HP AdvanceStack slaves.

hpicf8023RptrMonitorGroup

********* THIS GROUP IS DEPRECATED ********* A collection of extended counters for 802.3 repeaters in the HP AdvanceStack product line.

hpicf8023RptrMonitorSlaveGroup

********* THIS GROUP IS DEPRECATED ********* A collection of extended counters for HP AdvanceStack 802.3 slave repeaters.

hpicf8023MultiRptrBasicGroup

A collection of HP specific extensions to the 802.3 Repeater MIB for products in the HP AdvanceStack product line. This group supports devices with multiple repeater segments as well as devices with a single repeater segment.

hpicf8023MultiRptrMonitorGroup

A collection of extended counters for 802.3 repeaters in the HP AdvanceStack product line. This group supports devices with multiple repeater segments as well as devices with a single repeater segment.

hpicf8023RpMauAutoNegGroup

A collection of objects for managing MAUs attached to repeater ports with managed auto-negotiation.

hpicf8023Rptr100BasicGroup

A collection of HP specific extensions to the 802.3 Repeater MIB for products in the HP AdvanceStack product line. This group supports devices with multiple repeater segments as well as devices with a single repeater segment. This group supports devices ...