MIBs list
- Mac-Based-Authentication-MIB
- MAU-MIB
- Management information for 802.3 MAUs.
- MCAST-FILTER-MIB
- The Structure of multicast filter management for the
proprietary enterprise.
- MCAST-SNOOPING-MIB
- The structure of IGMP&MLD snooping for
the proprietary enterprise.
- MCAST-VLAN-MIB
- The structure of IGMP&MLD snooping multicast VLAN for
the proprietary enterprise
- MERITAGE-MIB
- MESSAGE-TRACKING-MIB ING-MIB
- The MIB module describing Lotus/SoftSwitch message tracking
- MG-SNMP-UPS-MIB
-
- MIP-MIB
- The MIB Module for the Mobile IP
- MLD-SNOOPING-MIB
- The Structure of MLD snooping management for the
proprietary enterprise.
- MODULES-MIB
- MPLS-L3VPN-STD-MIB
- This MIB contains managed object definitions for the
Layer-3 Multiprotocol Label Switching Virtual
Private Networks
- MPLS-LSR-MIB
- This MIB contains managed object definitions for the
Multiprotocol Label Switching (MPLS) Router as
defined in: Rosen, E., Viswanathan, A., and R.
Callon, Multiprotocol Label Switching Architecture,
Internet Draft ,
February 2000.
- MPLS-LSR-STD-MIB
- This MIB module contains managed object definitions for
the Multiprotocol Label Switching (MPLS) Router
- MPLS-MIB
- The MIB module for Multi-Protocol Label Switched Paths.
- MPLS-TE-MIB
- This MIB module contains managed object
definitions for MPLS Traffic Engineering (TE)
- MPLS-TE-STD-MIB
- MPLS-VPN-MIB
- This MIB contains managed object definitions for the
Multiprotocol Label Switching (MPLS)/Border Gateway
Protocol (BGP) Virtual Private Networks (VPNs) as
defined in : Rosen, E., Viswanathan, A., and R.
Callon, Multiprotocol Label Switching Architecture,
RFC3031
- MPOA-MIB
- This module defines a portion of the management
information base (MIB) for managing Multiprotocol Over
ATM clients and servers which was revised based
on MPOA Errata contained in MPOA v1.1.
- MRD-MIB
- MSIPBOOTP-MIB
- This MIB defines the management information for the BOOTP Protocol. The information in this MIB is divided
into 3 groups:
1. Global Group
Contains the global information BOOTP protocol Information contained in this group is independent of the interfaces
over which the protocol is enabled.
2. Interface Group
Contains RIP configuration information and statistics specific
to each interface. - MSIPRIP2-MIB
- This MIB defines the management information for the Routing Information
Protocol Version 2 ( RIP v2). The information in this MIB is divided
into 3 groups:
1. Global Group.
Contains the global information and statistics for the RIP protocol
Information contained in this group is independent of the interfaces
over which the protocol is enabled.
2. Interface Group.
Contains RIP configuration information and statistics specific
to each interface.
3. Peer Group.
Contains statistics pertaining to RIP peers. - MSIPX-MIB
- This MIB defines the management information for a system using the IPX protocol. The MIB consists of four groups:
1. Base Group - contains general information about IPX.
2. Interface Group - contains information about all interfaces used by IPX.
3. Forwarding Group - contains generic routing information that must be provided by any IPX routing protocol.
4. Services Group - contains information about all known services.
This MIB is designed to provide a basic framework for the management
of systems implementing the IPX protocol. Additional MIBs may be
created (especially in the area of IPX routing protocols) to contain
more specific information. Whenever possible, these additional MIBs
should follow the format of this IPX MIB.
- MSRIPSAP-MIB
- This MIB defines the management information for the RIP and SAP
protocols running in an IPX enviroment. It provides information in
addition to that contained in the IPX MIB itself.
- MSSQLSERVER-MIB
- MSTP-MIB
- The MIB module for managing MSTP.
- MTA-MIB
- MULTIPLE-BRIDGE-MIB
- MYLEXDAC960SCSIRAIDCONTROLLER-MIB ING-MIB
- MYLEXRAID-MIB
