tray1-fuser-temperature - tray1-fuser-temperature - 2100_snmp

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a HP device in your network.

tray1-fuser-temperature

tray1-fuser-temperature
1.3.6.1.4.1.11.2.3.9.4.2.1.4.1.3.3.1.13

The fuser temperature to be used when printing media from Tray 1. The value zero is the default temperature. Values less than zero are progressively lower and values greater than zero are progressively higher. The range of values supported is device specific. Additional information: HP LaserJet 2100 Series supports 3 fuser temperatures. Zero (0) is the default temperature, one(1) is a higher temperature (for use on media like cardstock), negative one (-1) is a lower temperature (for use on media like transparencies). Setting to an unsupported value causes the printer to snap to the nearest supported value and to return status along with the actual value that was written. The snap values are as follows: <=-1 snaps to -1 >=1 snaps to 1

Back to 2100_snmp MIB page.

IPHost Network monitor allows you to monitor tray1-fuser-temperature on Hewlett Packard device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco multiplexers right now.

MIBs list