cD11HtMacMPDUDensity - Cisco DOT11 Ht Mac MPDU Density - CISCO-DOT11-HT-MAC-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

cD11HtMacMPDUDensity

Cisco DOT11 Ht Mac MPDU Density
1.3.6.1.4.1.9.9.626.1.1.1.1.9

This object represents the minimum time between the start of adjacent MPDUs within an A-MPDU. This time is measured at the PHY service access-point; the number of bytes between the start of two consecutive MPDUs in A-MPDU shall be equal or greater than (MPDU-density*PHY-bit-rate)/8. The encoding of the minimum time to this object is as follows. 'noTimeRestriction' - no time restriction between the start of adjacent MPDUs. 'oneEighth' - 1/8 microseconds 'oneFourth' - 1/4 microseconds 'half' - 1/2 microseconds 'one' - 1 microsecond 'two' - 2 microseconds 'four' - 4 microseconds 'eight' - 8 microseconds.

Back to CISCO-DOT11-HT-MAC-MIB MIB page.

IPHost Network monitor allows you to monitor cD11HtMacMPDUDensity on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco optical switches right now.

Easy monitoring of cD11HtMacMPDUDensity with IPHost tools

MIBs list