Cisco DOT3 Oam Table

1.3.6.1.4.1.9.10.136.1.1

This table contains the primary controls and status for the OAM capabilities of an Ethernet like interface. There will be one row in this table for each Ethernet like interface in the system that supports the OAM functions defined in [802.3ah]. ::= { cdot3OamObjects 1 } SYNTAX Cdot3OamEntry MAX-ACCESS not-accessible STATUS current DESCRIPTION An entry in the table, containing information on the Ethernet OAM function for a single Ethernet like interface. Entries in the table are created automatically for each interface supporting Ethernet OAM. The status of the row entry can be determined from cdot3OamOperStatus. A cdot3OamEntry is indexed in the cdot3OamTable by the ifIndex object of the Interfaces MIB. INDEX { ifIndex } ::= { cdot3OamTable 1 } Cdot3OamEntry ::= SEQUENCE { cdot3OamAdminState INTEGER, cdot3OamOperStatus INTEGER, cdot3OamMode INTEGER, cdot3OamMaxOamPduSize Unsigned32, cdot3OamConfigRevision Unsigned32, cdot3OamFunctionsSupported BITS } SYNTAX INTEGER { disabled(1), enabled(2) } MAX-ACCESS read-write STATUS current DESCRIPTION This object is used to provision the default administrative OAM mode for this interface. This object represents the desired state of OAM for this interface. The cdot3OamAdminState always starts in the disabled(1) state until an explicit management action or configuration information retained by the system causes a transition to the enabled(2) state. When enabled(2), Ethernet OAM will attempt to operate over this interface. REFERENCE "[802.3ah], 30.3.6.1.2