ctron-cdp-mib Download

ctCDPNeighborLastChange

The value of sysUpTime at the time the cdpNeighborTable was subject to these events: row insertion, row deletion

ctCDPNeighborLastDelete

The value of sysUpTime the last time an entry in the ctCDPNeighborTable was deleted. This should be polled at an interval no greater than one second. When it changes, the whole table should be reread by management with a timeMark of 0 to rebuild connectiv ...

ctCDPNeighborTable

The CommonNeighborTable holds all known neighbors speaking cdp protocols.

ctCDPNeighborEntry

An entry containing objects pertaining to neighbor devices speaking CDP protocols.

ctCDPNeighborTimeMark

A TimeFilter for this entry as defined in RFC 2021.

ctCDPNeighborMAC

The interface mac address of neighboring entity.

ctCDPNeighborIP

The IP address of SNMP agent on neighboring entity from which corresponding data for this port may be obtained. In the case of unnumbered IP Interfaces, this may not be the same as the port.

ctCDPNeighborPort

The ifIndex of the remote port. Note, there may not be an IP Interface associated with this port.

ctCDPNeighborType

The type of entity. This value is used to determine the general type of the object or service connected to a given port. In general, it is better to use system group sysServices to obtain an object's functionality.

ctCDPNeighborChassisMAC

The MAC Address of the chassis in architectures where many manageable elements exist within a given chassis. If no containing chassis exists, exists, this value must be set to 000000:000000

ctCDPNeighborChassisIP

The IP address of the chassis itself. If no containing chassis exists, this value must be set to 0.0.0.0

ctCDPNeighborDescription

A textual description of the neighbor. It should contain operator diagnostic information similar to sysDescr: system type, firmware version...

ctCDPNeighborPortName

The value of object ifName of the neighbor's port.

ctCDPNeighborCapability

The current capabilities of the neighbor port.

ctCDPGlobalStatus

The state of CDP for this entire managed entity. autoEnable(3) should the default mode for new implementations. In autoEnable mode, the device listens for CDP messages and upon receipt, begins sending CDP messages of the same version and type as received.

ctCDPAuthenticationCode

The authentication code may be set to create individual CDP domains. CDP packets that arrive on a port must contain this string. This authentication code is global for the entire managed entity. The default for this string is 16 nulls.

ctCDPPortTable

This table shows enable/disable CDP status for each port.

ctCDPPortTableEntry

Each entry is indicative of a particuliar port in the system.

ctCDPPort

The ifIndex for a physical port. ifConnectorPresent is true(1) defines a physical port on which cdp pdus will be emitted.

ctCDPPortStatus

The current state administrative of cdp on a physical port. The ability to enable and disable the sending of CDP pdu's on a per port basis is controlled here.

ctCDPTransmitFrequency

The rate in seconds at which CDP pdu's are sent on all enabled ports.

ctCDPHoldTime

The maximum amount of time in seconds to wait before aging out an entry in the ctCDPNeighborTable. The agent may choose to change this value based on the hold time it receives from other devices so as to have a stable neighbor table which ages out entries ...

ctCDPVersion

The CDP version supported by this device as a bit string. For example, given support for two versions of cdp: 3 and 4 the bit representation in big endian form would be: 00001100.

ctCDPInPackets

Count of CDP packets received by the device over all the ports.

ctCDPOutPackets

Count of CDP packets successfully transmitted by the device over all the ports.

ctCDPInvalidVersionPackets

Count of CDP packets received with version not supported by the device.

ctCDPParseErrorPackets

Count of CDP packets received and could not be parsed successfully by the device.

ctCDPTransmitErrors

Count of errors occured by the device while trying to transmit CDP packets.

ctCDPMemoryErrors

Count of memory errors occured in the device while either trying to process the CDP packet or adding the neighbor entry or while trying to send a CDP packet.

ctCdpGroupV10

The set of managed objects that make up version 2 of the CTRON-CDP-MIB.