atmSigEmitCldPtyEvents - Cisco ATM Sig Emit Called Party Events - ATM2-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

atmSigEmitCldPtyEvents

Cisco ATM Sig Emit Called Party Events
1.3.6.1.2.1.37.1.14.1.3.1.10

Number of Called Party Responsible For Unsuccessful Call transmitted from this interface. This counter is incremented when a RELEASE, RELEASE COMPLETE (only when not preceded by a RELEASE message for the same call), ADD PARTY REJECT, or STATUS message that contains one of the following cause code values is transmitted (Note: These cause values apply to both UNI3.0 and UNI3.1): Cause Value Meaning 17 user busy 18 no user responding 21 call rejected 22 number changed 23 user rejects all calls with calling line identification restriction (CLIR) 27 destination out of order 31 normal, unspecified 88 incompatible destination NOTE: For this counter, RELEASE COMPLETE messages that are a reply to a previous RELEASE message and contain the same cause value, are redundant (for counting purposes) and should not be counted. Note: Cause Value #30 'response to STATUS ENQUIRY' was not included in this memo since it did not apply to a hard failure.

Back to ATM2-MIB MIB page.

IPHost Network monitor allows you to monitor atmSigEmitCldPtyEvents on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco switches right now.

How to get atmSigEmitCldPtyEvents value right now?

MIBs list