Cisco Hot Standby Routing Protocol Ext Sec Address Entry

1.3.6.1.4.1.9.9.107.1.1.2.1

The CHsrpExtSecAddrEntry allows creation of secondary IP Addresses for each cHsrpGrpEntry row. Secondary addresses can be added by setting cHsrpExtSecAddrRowStatus to be active. The value of cHsrpExtSecAddrRowStatus may be set to destroy at any time. Entries may not be created via SNMP without explicitly setting cHsrpExtSecAddrRowStatus to either 'createAndGo' or 'createAndWait'. Entries can be created and modified via the management protocol or by the device's local management interface. If the row is not active, and a local management interface command modifies that row, the row may transition to active state. A row which is not in active state will timeout after a configurable period (five minutes by default). This timeout period can be changed by setting cHsrpConfigTimeout. Before creation of a cHsrpExtSecAddrEntry row, either cHsrpGrpConfiguredVirtualIpAddr or cHsrpGrpLearnedVirtualIpAddr must have a valid IP Address. This is because a secondary ip address cannot be created unless the primary ip address has already been set. To create a new cHsrpExtSecAddrEntry row, a management station should choose the ifIndex of the interface which is to be added as part of an HSRP group. Also, an HSRP group number and a cHsrpExtSecAddrAddress should be chosen. Deleting a {ifIndex, cHsrpGrpNumber} row in the cHsrpGrpTable will delete all corresponding rows in the cHsrpExtSecAddrTable. Deleting a primary address value in the cHsrpGrpEntry row will delete all secondary addresses for the same {ifIndex, cHsrpGrpNumber} pair.