cpwVcInboundMode - Cisco Pseudo Wire Vc Inbound Mode - CISCO-IETF-PW-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

cpwVcInboundMode

Cisco Pseudo Wire Vc Inbound Mode
1.3.6.1.4.1.9.10.106.1.2.1.7

This object is used to enable greater security for implementation that use per platform VC label space. In strict mode, packets coming from the PSN are accepted only from tunnels that are associated to the same VC via the inbound tunnel table in the case of MPLS, or as identified by the source IP address in case of L2TP or IP PSN. The entries in the inbound tunnel table are either explicitly configured or implicitly known by the maintenance protocol used for VC set-up. If such association is not known, not configured or not desired, loose mode should be configured, and the node should accept the packet based on the VC label only regardless of the outer tunnel used to carry the VC.

Back to CISCO-IETF-PW-MIB MIB page.

IPHost Network monitor allows you to monitor cpwVcInboundMode on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco multiplexers right now.

Easy monitoring of cpwVcInboundMode with IPHost tools

MIBs list