docsQosParamSetNomPollInterval - DOCSIS Qos Param Set Nom Poll Interval - DOCS-QOS-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

docsQosParamSetNomPollInterval

DOCSIS Qos Param Set Nom Poll Interval
1.3.6.1.4.1.2011.2.25.127.7.1.2.1.15

between successive unicast request opportunities on an upstream service flow. This object applies only to upstream service flows with schedulingType of value nonRealTimePollingService(3), realTimePollingService(4), and unsolictedGrantServiceWithAD(5). The parameter is mandatory for realTimePollingService(4). If the parameter is omitted with nonRealTimePollingService(3), the CMTS uses an implementation dependent value. If the parameter is omitted with unsolictedGrantServiceWithAD(5), the CMTS uses as a default value the value of the Nominal Grant Interval parameter. In all cases, the CMTS reports the value it is using when the parameter is applicable. The CM reports the signaled parameter value if it was signaled, and 0 otherwise. If the referenced parameter is not applicable to the direction or scheduling type of the corresponding DOCSIS QOS Parameter Set, both CMTS and CM report this object's value as 0. REFERENCE "SP-RFIv1.1-I07-010829, Appendix C.2.2.6.4

Back to DOCS-QOS-MIB MIB page.

IPHost Network monitor allows you to monitor docsQosParamSetNomPollInterval on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco routers right now.

Easy monitoring of docsQosParamSetNomPollInterval with IPHost tools

MIBs list