frErrType - fr Err Type - FRAME-RELAY-DTE-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

frErrType

fr Err Type
1.3.6.1.2.1.10.32.3.1.2

The type of error that was last seen on this interface: receiveShort: frame was not long enough to allow demultiplexing - the address field was incomplete, or for virtual circuits using Multiprotocol over Frame Relay, the protocol identifier was missing or incomplete. receiveLong: frame exceeded maximum length configured for this interface. illegalAddress: address field did not match configured format. unknownAddress: frame received on a virtual circuit which was not active or administratively disabled. dlcmiProtoErr: unspecified error occurred when attempting to interpret link maintenance frame. dlcmiUnknownIE: link maintenance frame contained an Information Element type which is not valid for the configured link maintenance protocol. dlcmiSequenceErr: link maintenance frame contained a sequence number other than the expected value. dlcmiUnknownRpt: link maintenance frame contained a Report Type Information Element whose value was not valid for the configured link maintenance protocol. noErrorSinceReset: no errors have been detected since the last cold start or warm start.

Back to FRAME-RELAY-DTE-MIB MIB page.

IPHost Network monitor allows you to monitor frErrType on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco routers right now.

Easy monitoring of frErrType with IPHost tools

MIBs list