With IPHost Network Monitor you can run simple snmp requests against a Nortel device in your network.
frAtmLmiProcedures
Frame Relay Atm Lmi Procedures
This attribute selects the procedures to be used for the Local Management Interface. The following procedures are supported: none: no Local Management Interface procedures are running on this interface. This accommodates Frame Relay user equipment that has not implemented any LMI procedures. The remaining attributes of this group are ignored. vendorForum: Local Management Interface procedures from the Vendor Forum specification are supported on this interface. DLCI 1023 is used for the LMI protocol. This value cannot be used if the side attribute is both. ansi: Local Management Interface procedures from the ANSI specification are supported. DLCI 0 is used for the LMI protocol. itu: Local Management Interface procedures from the ITU-T specification are supported. DLCI 0 is used for the LMI protocol. Was previously ccitt. autoConfigure: The interface determines automatically which Local Management Interface procedures to use. This value cannot be used if the side attribute is user. The procedures currently in use can be seen in the operational attribute opProcedures.
Back to Nortel-Magellan-Passport-FrameRelayAtmMIB MIB page.
IPHost Network monitor allows you to monitor frAtmLmiProcedures on Allied Telesis device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Nortel secure routers right now.
