frUniLtsPatDefaultPayloadPattern - Frame Relay Uni Lts Pat Default Payload Pattern

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Nortel device in your network.

frUniLtsPatDefaultPayloadPattern

Frame Relay Uni Lts Pat Default Payload Pattern

This attribute specifies the payload of each frame. The value specified is in hexadecimal, where every two digits represent a byte. A maximum of 24 digits (12 bytes) may be set, after which the pattern will repeat in the payload (depending on repeatPattern attribute). NOTE: If a RFC 1490 header is specified, via the 1490Header attribute, the specified pattern will begin following the header (i.e. at the 9th byte in the payload).

Back to Nortel-Magellan-Passport-FrameRelayUniMIB MIB page.

IPHost Network monitor allows you to monitor frUniLtsPatDefaultPayloadPattern on Allied Telesis device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Nortel secure routers right now.

Easy monitoring of frUniLtsPatDefaultPayloadPattern with IPHost tools

MIBs list