snaNodeOperLuTermDefault - sna Node Operational Lu Term Default - SNA-NAU-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

snaNodeOperLuTermDefault

sna Node Operational Lu Term Default
1.3.6.1.2.1.34.1.1.3.1.7

The value identifies the default method used to deactivate LUs for this Node. For LU6.2s, 'unbind(1)' is the only valid value. unbind(1) - terminate the LU-LU session by sending an SNA UNBIND request. termself(2) - terminate the LU-LU session by sending an SNA TERM-SELF (Terminate Self) request on the SSCP-LU session. The SSCP will inform the remote session LU partner to send an UNBIND request to terminate the session. rshutd(3) - terminate the LU-LU session by sending an SNA RSHUTD (Request ShutDown) request to the remote session LU partner. The remote LU will then send an UNBIND request to terminate the session. poweroff(4) - terminate the LU-LU session by sending either an SNA LUSTAT (LU Status) request on the LU-LU session or an SNA NOTIFY request on the SSCP-LU session indicating that the LU has been powered off. Sending both is also acceptable. The result should be that the remote session LU partner will send an UNBIND to terminate the session. This object describes the default behavior for this Node; however, it is possible that for a specific LU the behavior indicated by the snaLuOperTerm object is different.

Back to SNA-NAU-MIB MIB page.

IPHost Network monitor allows you to monitor snaNodeOperLuTermDefault on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco routers right now.

Easy monitoring of snaNodeOperLuTermDefault with IPHost tools

MIBs list