The objects described here can be monitored with the IPHost Network Monitor.
You can start SNMP monitoring using free 30-day trial version of IPHost right now.
OID list for processor time
- cpu Percent Processor Time
- cpuPercentProcessorTime 1.3.6.1.4.1.311.1.1.3.1.1.2.1.3 (defined in WINDOWS-NT-PERFORMANCE)
Processor Time is expressed as a percentage of the elapsed time that a processor is busy executing a non-Idle thread. It can be viewed as the fraction of the time spent doing useful work. Each processor is assigned an Idle thread in the Idle process which consumes those unproductive processor cycles not used by any other threads. - process Percent Processor Time
- processPercentProcessorTime 1.3.6.1.4.1.311.1.1.3.1.1.7.1.3 (defined in WINDOWS-NT-PERFORMANCE)
Processor Time is the percentage of elapsed time that all of the threads of this process used the processor to execute instructions. An instruction is the basic unit of execution in a computer, a thread is the object that executes instructions, and a process is the object created when a program is run. Code executed to handle certain hardware interrupts or trap conditions may be counted for this process. - ntsystem Percent Total Processor Time
- ntsystemPercentTotalProcessorTime 1.3.6.1.4.1.311.1.1.3.1.1.33.9 (defined in WINDOWS-NT-PERFORMANCE)
The % Total Processor Time is the average percentage of time that all the processors on the system are busy executing non-idle threads. On a multi-processor system, if all processors are always busy this is 100%, if all processors are 50% busy this is 50% and if 1/4th of the processors are 100% busy this is 25%. It can be viewed as the fraction of the time spent doing useful work. Each processor is assigned an Idle thread in the Idle process which consumes those unproductive processor cycles not used by any other threads. - sfps Call Processor Resources Table State Time
- sfpsCPResourcesTableStateTime 1.3.6.1.4.1.52.4.2.4.2.2.2.3.1.1.5 (defined in ctron-sfps-base-mib)
The last time that this Call Processor has changed states. - sfps Call Processor Resources Config Time
- sfpsCPResourcesConfigTime 1.3.6.1.4.1.52.4.2.4.2.2.2.3.1.1.21 (defined in ctron-sfps-base-mib)
Number of time ticks since the last configuration change. - Cisco Channel Interface Processor Cmpc Transmission Group Operation Last Sequence Number Failure Time
- cipCmpcTgOperLastSeqNumFailureTime 1.3.6.1.4.1.9.9.72.1.2.1.1.3 (defined in CISCO-CIPCMPC-MIB)
This object describes the value of sysUpTime when this CMPC TG last detected a sequence number error. If the CMPC TG has not failed, then this value shall be zero. - Channel Interface Processor Card Csna Admin Block Delay Time
- cipCardCsnaAdminBlockDelayTime 1.3.6.1.4.1.9.9.33.1.1.1.1.3 (defined in CISCO-CIPCSNA-MIB)
The Block Delay Time is the maximum amount of time the CSNA feature can hold a set of requests before it must transmit the block to the host. The Block must be sent when this time has expired, even if the block has not reached the suggested Block Delay Length. - Channel Interface Processor Card Csna Statistics Blocks Tx By Block Delay Time
- cipCardCsnaStatsBlocksTxByBlockDelayTime 1.3.6.1.4.1.9.9.33.1.1.3.1.7 (defined in CISCO-CIPCSNA-MIB)
The number of Blocks Transmitted when the Block Delay Time has been exceeded. - Channel Interface Processor Card Csna Statistics Bytes Tx By Block Delay Time
- cipCardCsnaStatsBytesTxByBlockDelayTime 1.3.6.1.4.1.9.9.33.1.1.3.1.8 (defined in CISCO-CIPCSNA-MIB)
The number of Bytes Transmitted when the Block Delay Time has been exceeded. - Channel Interface Processor Card Csna Statistics HC Bytes Tx By Block Delay Time
- cipCardCsnaStatsHCBytesTxByBlockDelayTime 1.3.6.1.4.1.9.9.33.1.1.3.1.9 (defined in CISCO-CIPCSNA-MIB)
The number of Bytes Transmitted when the Block Delay Time has been exceeded. NOTE: This is a 64 bit (High Capacity) version of the cipCardCsnaStatsBytesTxByBlockDelayTime counter for use with SNMP Version 2 Managers - Cisco Channel Interface Processor Icmp In Time Excds
- cipIcmpInTimeExcds 1.3.6.1.4.1.9.9.32.1.3.1.1.4 (defined in CISCO-CIPTCPIP-MIB)
The number of ICMP Time Exceeded messages received.
