ADTRAN-AOS-3G Download
A MIB module for monitoring 3G module values.
IPHost Network Monitor offer an easy way of SNMP monitoring your ADTRAN Servers, Routers, Switches, Bridges,
Firewalls, Repeaters.
OID list for ADTRAN-AOS-3G
- adGenAOS3GTraps
- configuration values and when statistical data reach certain thresholds.
- adGenAOS3GTable
- The table contains 3G cellular statistical data for the cellular interface.
- adGenAOS3GEntry
- This is an entry into the 3G table.
- adGenAOS3GNetworkAccessID
- The Network Access ID is the User ID submitted by the 3G Modem during Mobile IP authentication. For more information, refer to RFC 4282.
- adGenAOS3GHASS
- This OID displays whether the shared secret for the home agent has been set for Mobile IP authentication.
- adGenAOS3GHASPI
- The Home Agent Security Parameter Index uniquely identifies a security association for the home agent for use during Mobile IP authentication.
- adGenAOS3GAAASS
- This OID displays whether the shared secret for AAA has been set for Mobile IP authentication.
- adGenAOS3GAAASPI
- The AAA Security Parameter Index uniquely identifies a security association for AAA for use during Mobile IP authentication.
- adGenAOS3GReverseTunneling
- This OID describes if a tunnel is setup from the 3G module's care of address to the home agent. A care of address is a temporary IP address for a mobile device.
- adGenAOS3GHomeAddress
- The permanent home IP address for the 3G module in the cellular network.
- adGenAOS3GPrimaryHomeAddress
- The primary IP address of the 3G module's home agent.
- adGenAOS3GSecHomeAddress
- The secondary IP address of the 3G module's home agent.
- adGenAOS3GRSSI
- The Receive Signal Strength Indicator for the cellular connection. This value is a measurement of signal strength.
- adGenAOS3GECIO
- The Ec/Io for the cellular connection. This is the ratio of received pilot energy to the total received energy. The value is similar to signal-to-noise ratio.
- adGenAOS3GPnOffset
- The Pn Offset for the cellular connection. Base stations assigned to a particular frequency carrier operate at the same center frequency. The PN offset is used to distinguish base stations from one another.
- adGenAOS3GServiceType
- The current Cellular Service Type for the cellular connection.
- adGenAOS3GServiceTypePreference
- The current Cellular Service Type Preference for the cellular connection. Cellular Service Type can be forced to 1xRTT mode or 1xEVDO mode. By default, it is set to Hybrid or AUTO mode which chooses the best available signal.
- adGenAOS3GConnectionState
- The current Connection State for the cellular connection.
- adGenAOS3GECIOIntegerValue
- The Ec/Io for the cellular connection displayed in integer form. This is the ratio of received pilot energy to the total received energy. The value is similar to signal-to-noise ratio. EC/IO values typically are represented as a value with a decimal place ...
- adGenAOS3GHardwareDataTable
- The table contains profile information for the 3G cellular interface.
- adGenAOS3GHardwareDataEntry
- This is an entry into the 3G hardware data table.
- adGenAOS3GSystemID
- The System Identification number is the identifier for a cellular network in a certain area.
- adGenAOS3GNetworkID
- The Network Identification number identifies a subset of a particular SID corresponding to different networks.
- adGenAOS3GPrefferedRoamList
- The PRL is a database of cell towers that the cellular modem can roam on. This OID specifies the current version of that database that is programmed onto the cellular modem.
- adGenAOS3GMobileDirNumber
- The MDN is the 10 digit phone number assigned to the 3G module.
- adGenAOS3GESN
- The Electronic Serial Number is is a unique number that identifies the 3G module.
- adGenAOS3GMobileStationID
- The MSID is a 10 digit number that identifies the 3G module in the network.
- adGenAOS3GHardwareVersion
- The hardware version of the 3G modem.
- adGenAOS3GFirmwareVersion
- The firmware version of the 3G modem.
- adGenAOS3GThresholdDataTable
- The table contains settings regarding whether the trap is enabled and threshold values for certain traps.
- adGenAOS3GThresholdDataEntry
- This is an entry into the 3G threshold data table.
- adGenAOS3GEnableTraps
- This OID indicates whether traps are enabled for the interface.
- adGenAOS3GRSSIThreshold
- This is a value from (-200..200) that sets the threshold for an RSSI trap to occur. When the RSSI is below this value, it will cause an RSSI alarm trap. When the RSSI rises above this value, it will cause an RSSI cleared trap.
- adGenAOS3GECIOThreshold
- This is a value from (-200..200) that sets the threshold for an ECIO trap to occur. When the ECIO is below this value, it will cause an ECIO alarm trap. When the ECIO rises above this value, it will cause an ECIO cleared trap.
- adGenAOS3GTableGroup
- This group contains 3G cellular statistical data for profile information.
- adGenAOS3GHardwareDataGroup
- This group contains 3G cellular statistical data for hardware information.
- adGenAOS3GThresholdDataGroup
- This group contains threshold data for enabling 3G interface thresholds.
Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring network devices right now.
