ALCATEL-IND1-PORT-MIB Download
This module describes an authoritative enterprise-specific Simple
Network Management Protocol (SNMP) Management Information Base (MIB):
This group contains the configuration information data
for the Ethernet Switching Module.
The right to make changes in specification and other information
contained in this document without prior notice is reserved.
No liability shall be assumed for any incidental, indirect, special, or
consequential damages whatsoever arising from or related to this
document or the information contained herein.
Vendors, end-users, and other interested parties are granted
non-exclusive license to use this specification in connection with
management of the products for which it is intended to be used.
IPHost Network Monitor offer an easy way of SNMP monitoring your Alcatel Servers, Routers, Switches, Bridges,
Firewalls, Repeaters.
OID list for ALCATEL-IND1-PORT-MIB
- esmDrvTrapDrops
- Partitioned port (separated due to errors).
- esmConfTable
- A list of ESM Physical Port instances.
- esmConfEntry
- A ESM Physical Port entry.
- esmPortSlot
- The physical Slot number for this Ethernet Port. Slot number has been added to be used by the private Trap.
- esmPortIF
- The on-board interface number for this Ethernet Port. Port Number has been added to be used by the private Trap.
- esmPortAutoSpeed
- The automatically detected port line speed of this ESM port.
- esmPortAutoDuplexMode
- The automatically detected port duplex mode of this ESM port. Note: GigaEthernet supports only Full duplex mode. Default value for 10/100 = Half duplex mode.
- esmPortCfgSpeed
- The configured port line speed of this ESM port.
- esmPortCfgDuplexMode
- The configured port duplex mode of this ESM port. Note: GigaEthernet support only full-duplex.
- esmPortCfgIFG
- Contains the setting of Inter-Frame Gap (IFG), in bytes for receive and transmit. The range is from 9 to 12 bytes. Note: The default value changed according to the Port type Default Bandwidth value 12 bytes 10Mbps 9600 nsec 100Mbps 9 ...
- esmPortPauseSlotTime
- Indicates the number of microseconds the other end-station waits after the reception of a pause frame. Note: Pause Flow control is not available for 10Mbps. For 100Mbps, the possible value range is 5120 nanosec to 0.3 sec. For 1Gbps, the possible value ra ...
- esmPortMaxFloodRate
- The value of the maximum flood rate, in Mbits/sec (the peak rate value in Mbps). Note: This value can apply to multicast too, according to esmPortFloodMulticastEnable. The default value changed according to the Port type: 10 Mbps/ 100 Mbps - 47 Mbps (12 ...
- esmPortFloodMcastEnable
- Enable/disable the maximum flood rate for flood or flood and multicast.
- esmPortCfgMaxFrameSize
- Configure the value of the maximum frame size allow. For 10/100: It is a range between 1518(untagged) and 1553 bytes. For GigaEthernet: It is a range between 1518 and 10240 bytes.
- esmPortCfgLongEnable
- Allow the user to change the maximun Frame size. Note: It is not configurable for 10/100 Ethernet port.
- esmPortCfgRuntEnable
- Allow the user to change the minimum Frame size.
- esmPortCfgRuntSize
- Configure the value of the minimum frame size allow per ports. The range is 0 to 64.
- esmPortCfgAutoNegotiation
- Allow the user to enable or disable the port auto negotiation.
- esmPortCfgCrossover
- Allow the user to configure port crossover.
- esmPortCfgFlow
- Allow the user to enable or disable the port flow.
- alcetherStatsTable
- A list of Ethernet statistics entries.
- alcetherStatsEntry
- A collection of statistics kept for a particular Ethernet interface. As an example, an instance of the etherStatsPkts object might be named alcetherStatsPkts.1
- alcetherClearStats
- Used to Clear all Statistics counters. By default, this object contains zero value.
- alcetherLastClearStats
- The value of SysUpTime at the time of all the statistics counters are cleared. By default, this object contains a zero value.
- alcetherStatsCRCAlignErrors
- The total number of packets received that had a length (excluding framing bits, but including FCS octets) of between 64 and 1518 octets, inclusive, but but had either a bad Frame Check Sequence (FCS) with an integral number of octets (FCS Error) or a bad ...
- alcetherStatsRxUndersizePkts
- The total number of packets received that were less than 64 octets long (excluding framing bits, but including FCS octets) and were otherwise well formed.
- alcetherStatsTxUndersizePkts
- The total number of packets transmitted that were less than 64 octets long (excluding framing bits, but including FCS octets) and were otherwise well formed.
- alcetherStatsTxOversizePkts
- The total number of packets transmitted that were longer than 1518 octets long (excluding framing bits, but including FCS octets) and were otherwise well formed.
- alcetherStatsRxJabbers
- The total number of packets received that were longer than 1518 octets (excluding framing bits, but including FCS octets), and had either a bad Frame Check Sequence (FCS) with an integral number of octets (FCS Error) or a bad FCS with a non-integral numbe ...
- alcetherStatsRxCollisions
- The best estimate of the total number of collisions on this Ethernet segment (in reception). Only for Ethernet Interfaces. The value returned will depend on the location of the RMON probe. Section 8.2.1.3 (10BASE-5) and section 10.3.1.3 (10BASE-2) of IEEE ...
- alcetherStatsTxCollisions
- The best estimate of the total number of collisions on this Ethernet segment (in transmition). Only for Ethernet Interfaces. The value returned will depend on the location of the RMON probe. Section 8.2.1.3 (10BASE-5) and section 10.3.1.3 (10BASE-2) of IE ...
- alcetherStatsPkts64Octets
- The total number of packets (including bad packets) received that were 64 octets in length (excluding framing bits but including FCS octets).
- alcetherStatsPkts65to127Octets
- The total number of packets (including bad packets) received that were between 65 and 127 octets in length inclusive (excluding framing bits but including FCS octets).
- alcetherStatsPkts128to255Octets
- The total number of packets (including bad packets) received that were between 128 and 255 octets in length inclusive (excluding framing bits but including FCS octets).
- alcetherStatsPkts256to511Octets
- The total number of packets (including bad packets) received that were between 256 and 511 octets in length inclusive (excluding framing bits but including FCS octets).
- alcetherStatsPkts512to1023Octets
- The total number of packets (including bad packets) received that were between 512 and 1023 octets in length inclusive (excluding framing bits but including FCS octets).
- alcetherStatsPkts1024to1518Octets
- The total number of packets (including bad packets) received that were between 1024 and 1518 octets in length inclusive (excluding framing bits but including FCS octets). For both Ethernet and GigaEthernet.
- gigaEtherStatsPkts1519to4095Octets
- The total number of packets (including bad packets) received that were between 1519 and 4095 octets in length inclusive (excluding framing bits but including FCS octets). Only for GigaEthernet interfaces
- gigaEtherStatsPkts4096to9215Octets
- The total number of packets (including bad packets) received that were between 4096 and 9215 octets in length inclusive (excluding framing bits but including FCS octets). Only for GigaEthernet interfaces
- alcetherStatsPkts1519to2047Octets
- The total number of frames(including error packets) received that were between 1519 and 2047 bytes in length inclusive (excluding framing bits but including FCS bytes). ::= { alcetherStatsEntry 18 } SYNTAX Counter64 MAX-ACCESS read-only STATUS current DES ...
- alcetherStatsRxVlanTagPkts
- The total number of frames for which Type/Length field contains the VLAN protocol identifier (0x8100).
- alcetherStatsRxControlPkts
- The total number of frames that were recognized as control frames.
- alcetherStatsRxLenChkErrPkts
- The total number of frames for which the frame length field value in the Type/Length field does not match the actual data bytes length and is NOT a type field.
- alcetherStatsRxCodeErrPkts
- The total number of frames for which one or more nibbles were signaled as errors during reception of the frame.
- alcetherStatsRxDvEventPkts
- The total number of frames for which a RX_DV event (packet not too long enough to be valid packet) has been seen before the correct frame.
- alcetherStatsRxPrevPktDropped
- The total number of frames for which a packet has been dropped (because of too small IFG) before the correct frame.
- alcetherStatsTx64Octets
- The total number of transmitted frames of 64 bytes.
- alcetherStatsTx65to127Octets
- The total number of transmitted frames that were between 65 and 127 bytes in length inclusive (excluding framing bits but including FCS bytes).
- alcetherStatsTx128to255Octets
- The total number of transmitted frames that were between 128 and 255 bytes in length inclusive (excluding framing bits but including FCS bytes).
- alcetherStatsTx256to511Octets
- The total number of transmitted frames that were between 256 and 511 bytes in length inclusive (excluding framing bits but including FCS bytes).
- alcetherStatsTx512to1023Octets
- The total number of transmitted frames that were between 512 and 1023 bytes in length inclusive (excluding framing bits but including FCS bytes).
- alcetherStatsTx1024to1518Octets
- The total number of transmitted frames that were between 1024 and 1518 bytes in length inclusive (excluding framing bits but including FCS bytes).
- alcetherStatsTx1519to2047Octets
- The total number of transmitted frames that were between 1519 and 2047 bytes in length inclusive (excluding framing bits but including FCS bytes).
- alcetherStatsTx2048to4095Octets
- The total number of transmitted frames that were between 2048 and 4095 bytes in length inclusive (excluding framing bits but including FCS bytes).
- alcetherStatsTx4096Octets
- The total number of transmitted frames that were greater than or equal to 4096 bytes in length and less than Max frame length (excluding framing bits but including FCS bytes).
- alcetherStatsTxRetryCount
- The total number of collisions that the frames faced during transmission attempts.
- alcetherStatsTxVlanTagPkts
- The total number of transmitted frames for which Type/Length field contains the VLAN protocol identifier (0x8100).
- alcetherStatsTxControlPkts
- The total number of transmitted frames that were recognised as control frames.
- alcetherStatsTxLatePkts
- The total number of late collisions that occured beyond the collision window.
- alcetherStatsTxTotalBytesOnWire
- The total number of bytes transmitted on wire, including all bytes from collided attempts.
- alcetherStatsTxLenChkErrPkts
- The total number of transmitted frames for which the frame length field value in the Type/Length field does not match the actual data bytes length and is NOT a Type field.
- alcetherStatsTxExcDeferPkts
- The total number of frames that were deferred in excess of 6071 nibble-times in 100 Mbps, 24287 bit-times in 10 Mbps mode. These frames are dropped.(This stat is only in case of Half duplex and excessive defer bit reset).
- esmConfMIBGroup
- A collection of objects to support the management of global configuration parameters of the Ethernet ports.
- esmDetectedConfMIBGroup
- A collection of objects to support the Detected configuration parameters of the Ethernet ports.
- alcEtherStatsMIBGroup
- A collection of objects to provide all the statistics related to the Ethernet and GigaEthernert ports.
