ALCATEL-IND1-RIP-MIB

ALCATEL-IND1-RIP-MIB Download

MIBs list

This module describes an authoritative enterprise-specific Simple Network Management Protocol (SNMP) Management Information Base (MIB): For the Birds Of Prey Product Line Configuration Of Global RIP Configuration Parameters. The right to make changes in specification and other information contained in this document without prior notice is reserved. No liability shall be assumed for any incidental, indirect, special, or consequential damages whatsoever arising from or related to this document or the information contained herein. Vendors, end-users, and other interested parties are granted non-exclusive license to use this specification in connection with management of the products for which it is intended to be used.

IPHost Network Monitor offer an easy way of SNMP monitoring your Alcatel Servers, Routers, Switches, Bridges, Firewalls, Repeaters.

OID list for ALCATEL-IND1-RIP-MIB

alcatelIND1RIPMIBObjects
Branch for Routing Information Protocol (RIP) Subsystem Managed Objects.
alcatelIND1RIPMIBConformance
Branch for Routing Information Protocol (RIP) Subsystem Conformance Information.
alcatelIND1RIPMIBGroups
Branch for Routing Information Protocol (RIP) Subsystem Units Of Conformance.
alcatelIND1RIPMIBCompliances
Branch for Routing Information Protocol (RIP) Subsystem Compliance Statements.
alaRipProtoStatus
Global administration status of RIP.
alaRipHostRouteSupport
Enable or disable support for host routes.
alaRipRedistAdminStatus
Enable or disable redistribution of routes into RIP.
alaRipRedistRouteTag
A 32-bit value tagged to each RIP internal route while it is redistributed in to other routing protocol domains. The lower 16-bits typically indicate the autonomous system number.
alaRipForceHolddownTimer
Interval in seconds during which routing information regarding better paths is suppressed. A route enters into a forced holddown state when an update packet is received that indicates the route is unreachable and when this timer value is nonzero. After th ...
alaRipRouteNumber
The number of network routes in RIP routing table.
alaRipRedistProtoTable
Protocol based configuration for route redistribution using RIP.
alaRipRedistProtoEntry
A range of routes from a protocol to be redistributed using RIP.
alaRipRedistProtoId
The routing mechanism via which the routes, to be redistributed using RIP, are learned.
alaRipRedistProtoMetric
Default metric to be used for redistributing routes.
alaRipRedistProtoStatus
Add or Delete entries.
alaRipDebugLevel
Sets the level of Debugging for DRC RIP on this router. A level of 0 indicates no debugging.
alaRipDebugError
Administratively enables/disables debugging for DRC RIP ERROR messages if the alaRipDebugLevel is greater than 0.
alaRipDebugWarn
Administratively enables/disables debugging for DRC RIP Warning messages if the alaRipDebugLevel is greater than 0.
alaRipDebugRecv
Administratively enables/disables debugging for DRC RIP RECV messages if the alaRipDebugLevel is greater than 0
alaRipDebugSend
Administratively enables/disables debugging for DRC RIP SEND messages if the alaRipDebugLevel is greater than 0
alaRipDebugRdb
Administratively enables/disables debugging for DRC RIP Routing DataBase messages if the alaRipDebugLevel is greater than 0
alaRipDebugAge
Administratively enables/disables debugging for DRC RIP Database aging messages if the alaRipDebugLevel is greater than 0
alaRipDebugConfig
Administratively enables/disables debugging for DRC RIP configuration messages if the alaRipDebugLevel is greater than 0
alaRipDebugRedist
Administratively enables/disables debugging for DRC RIP Redistribution messages if the alaRipDebugLevel is greater than 0
alaRipDebugInfo
Administratively enables/disables debugging for DRC RIP Information messages if the alaRipDebugLevel is greater than 0
alaRipDebugSetup
Administratively enables/disables debugging for DRC RIP Setup messages if the alaRipDebugLevel is greater than 0
alaRipDebugTime
Administratively enables/disables debugging for DRC RIP Timer related messages if the alaRipDebugLevel is greater than 0
alaRipDebugAll
Administratively enables/disables all debugging for DRC RIP if the alaRipDebugLevel is greater than 0
alaRipRouteTable
RIP routing table which contains the network routes.
alaRipRouteEntry
RIP routing table which contains the network routes.
alaRipRouteDest
The destination IP address of this route.
alaRipRouteMask
The network mask for this route.
alaRipRouteNextHop
The address of the next hop to reach this route.
alaRipRouteType
The type of route.
alaRipRouteAge
The number of seconds since this route was last updated or otherwise determined to be correct.
alaRipRouteTag
The associated route tag
alaRipRouteMetric
The routing metric for this route.
alaRipRouteStatus
The row status variable, used according to row installation and removal conventions.
alaRipRedistRouteTable
A configuration table which controls the routes to be redistributed by RIP from other routing protocols.
alaRipRedistRouteEntry
An entry of alaRipRedistRouteTable which specifies a route or set of routes to be redistributed by RIP from another routing protocol.
alaRipRedistRouteProto
Protocol from which this route is to be imported into RIP.
alaRipRedistRouteDest
The destination IP address of this route.
alaRipRedistRouteMask
The network mask for this route.
alaRipRedistRouteMetric
The metric to be used for the redistributed route. A value of 0 means that the metric used should be the value configured in alaRipRedistProtoMetric for this protocol.
alaRipRedistRouteControl
Specifies how routes matching this entry are to be redistributed into RIP. The different mechanisms possible are to redistribute all the subnet routes, redistribute an aggregated route if there are one or more actual routes which match this entry or redis ...
alaRipRedistRouteTagMatch
Redistribute the route only when the route tag matches with this value. It defaults to -1 which matches all route tags.
alaRipRedistRouteEffect
Specifies whether the redistribution of routes in this range is allowed or denied.
alaRipRedistRouteStatus
The row status variable, used according to row installation and removal conventions.
alaRipMiscellaneousGroup
Collection of Miscellaneous objects for management of RIP.
alaRipRedistProtoGroup
Collection of objects for management of Route Redistribution Protocol.
alaRipDebugGroup
Collection of objects for management of Debug Information.
alaRipRouteGroup
Collection of objects for management of Network Route configuration.
alaRipRedistRouteGroup
Collection of objects for management of Route Redistribution configuration.

MIBs list