CISCO-IPSEC-POLICY-MAP-MIB Download
The MIB module maps the IPSec
entities created dynamically to the policy entities
that caused them. This is an appendix to the
IPSEC-MONITOR-MIB that has been proposed to
IETF for monitoring IPSec based Virtual Private
Networks.
IPHost Network Monitor offer an easy way of SNMP monitoring your Cisco Servers, Routers, Switches, Bridges,
Firewalls, Repeaters.
OID list for CISCO-IPSEC-POLICY-MAP-MIB
- ikePolMapTable
- The IPSec Phase-1 Internet Key Exchange Tunnel to Policy Mapping Table. There is one entry in this table for each active IPSec Phase-1 Tunnel.
- ikePolMapEntry
- Each entry contains the attributes associated with mapping an active IPSec Phase-1 IKE Tunnel to it's configured Policy definition.
- ikePolMapTunIndex
- The index of the IPSec Phase-1 Tunnel to Policy Map Table. The value of the index is the number used to represent this IPSec Phase-1 Tunnel in the IPSec MIB (ikeTunIndex in the ikeTunnelTable).
- ikePolMapPolicyNum
- The number of the locally defined ISAKMP policy used to establish the IPSec IKE Phase-1 Tunnel. This is the number which was used on the crypto command. For example, if the configuration command was: ==> crypto isakmp policy 15 then the value of this obj ...
- ipSecPolMapTable
- The IPSec Phase-2 Tunnel to Policy Mapping Table. There is one entry in this table for each active IPSec Phase-2 Tunnel.
- ipSecPolMapEntry
- Each entry contains the attributes associated with mapping an active IPSec Phase-2 Tunnel to its configured Policy definition.
- ipSecPolMapTunIndex
- The index of the IPSec Phase-2 Tunnel to Policy Map Table. The value of the index is the number used to represent this IPSec Phase-2 Tunnel in the IPSec MIB (ipSecTunIndex in the ipSecTunnelTable).
- ipSecPolMapCryptoMapName
- The value of this object should be the name of the IPSec Policy (cryptomap) as assigned by the operator while configuring the policy of the IPSec traffic. For instance, on an IOS router, the if the command entered to configure the IPSec policy was ==> cr ...
- ipSecPolMapCryptoMapNum
- The value of this object should be the priority of the IPSec Policy (cryptomap) assigned by the operator while configuring the policy of this IPSec tunnel. For instance, on an IOS router, the if the command entered to configure the IPSec policy was ==> c ...
- ipSecPolMapAclString
- The value of this object is the number or the name of the access control string (ACL) that caused this IPSec tunnel to be established. The ACL that causes an IPSec tunnel to be established is referenced by the cryptomap of the tunnel. The ACL identifies t ...
- ipSecPolMapAceString
- The value of this object is the access control entry (ACE) within the ACL that caused this IPSec tunnel to be established. For instance, if an ACL defines access for two traffic streams (FTP and SNMP) as follows: access-list 101 permit tcp 172.16.14.0 0.0 ...
- ipSecPhaseOnePolMapGroup
- This group consists of a: 1) IPSec Phase-1 Policy Map Table
- ipSecPhaseTwoPolMapGroup
- This group consists of a: 1) IPSec Phase-2 Policy Map Table
Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring network devices right now.
