CISCO-OSPF-MIB Download
An extension to the MIB module defined in
RFC 1850 for managing OSPF implimentation.
Most of the MIB definitions are based on
the IETF draft
< draft-ietf-ospf-mib-update-05.txt > .
Support for OSPF Sham link is also added
IPHost Network Monitor offer an easy way of SNMP monitoring your Cisco Servers, Routers, Switches, Bridges,
Firewalls, Repeaters.
OID list for CISCO-OSPF-MIB
- cospfRFC1583Compatibility
- Indicates metrics used to choose among multiple AS- external-LSAs. When cospfRFC1583Compatibility is set to enabled, only cost will be used when choosing among multiple AS-external-LSAs advertising the same destination. When cospfRFC1583Compatibility is s ...
- cospfOpaqueLsaSupport
- The router's support for Opaque LSA types.
- cospfTrafficEngineeringSupport
- The router's support for OSPF traffic engineering.
- cospfOpaqueASLsaCount
- The total number of Opaque AS link-state advertisements in the link state database.
- cospfOpaqueASLsaCksumSum
- The 32-bit unsigned sum of the Opaque AS link-state advertisements' LS checksums contained link state database.
- cospfAreaTable
- Information describing the configured parameters and cumulative statistics of the router's attached areas.
- cospfAreaEntry
- Information describing the configured parameters and cumulative statistics of one of the router's attached areas.
- cospfOpaqueAreaLsaCount
- The total number of Opaque Area and AS link-state advertisements in the link state database of this area.
- cospfOpaqueAreaLsaCksumSum
- The 32-bit unsigned sum of the Opaque Area and AS link-state advertisements' LS checksums contained link state database of this area. The sum can be used to determine if there has been a change in the link state database for Opaque Area and AS link-state ...
- cospfAreaNssaTranslatorRole
- Indicates an NSSA Border router's ability to perform NSSA translation of type-7 LSAs into type-5 LSAs.
- cospfAreaNssaTranslatorState
- Indicates if and how an NSSA Border router is performing NSSA translation of type-7 LSAs into type-5 LSAs. When this object set to enabled, the NSSA Border router's cospfAreaNssaExtTranslatorRole has been set to always. When this object is set to elected, ...
- cospfAreaNssaTranslatorEvents
- Indicates the number of Translator State changes that have occurred since the last boot-up.
- cospfLsdbTable
- The OSPF Process's Link State Database. This table is meant for Opaque LSA's
- cospfLsdbEntry
- A single Link State Advertisement.
- cospfLsdbType
- The type of the link state advertisement. Each link state type has a separate advertisement format.
- cospfLsdbSequence
- The sequence number field is a signed 32-bit integer. It is used to detect old and duplicate link state advertisements. The space of sequence numbers is linearly ordered. The larger the sequence number the more recent the advertisement.
- cospfLsdbAge
- This field is the age of the link state advertisement in seconds.
- cospfLsdbChecksum
- This field is the checksum of the complete contents of the advertisement, excepting the age field. The age field is excepted so that an advertisement's age can be incremented without updating the checksum. The checksum used is the sa ...
- cospfLsdbAdvertisement
- The entire Link State Advertisement, including its header.
- cospfIfTable
- The OSPF Interface Table describes the inter- faces from the viewpoint of OSPF.
- cospfIfEntry
- The OSPF Interface Entry describes one inter- face from the viewpoint of OSPF.
- cospfIfLsaCount
- The total number of link-local link state advertisements in this interface's link-local link state database.
- cospfIfLsaCksumSum
- The 32-bit unsigned sum of the link-state advertisements' LS checksums contained in this interface's link-local link state database. The sum can be used to determine if there has been a change in the interface's link state database, and to compare the int ...
- cospfVirtIfTable
- Information about this router's virtual inter- faces.
- cospfVirtIfEntry
- Information about a single Virtual Interface.
- cospfVirtIfLsaCount
- The total number of link-local link state advertisements in this virtual interface's link-local link state database.
- cospfVirtIfLsaCksumSum
- The 32-bit unsigned sum of the link-state advertisements' LS checksums contained in this virtual interface's link-local link state database. The sum can be used to determine if there has been a change in the virtual interface's link state database, and to ...
- cospfShamLinkTable
- Information about this router's sham links
- cospfShamLinkEntry
- Information about a single sham link
- cospfShamLinkAreaId
- The Transit Area that the Virtual Link traverses. By definition, this is not 0.0.0.0
- cospfShamLinkLocalIpAddress
- The Local IP address of the sham link.
- cospfShamLinkNeighborId
- The Router ID of the other end router of the sham link.
- cospfShamLinkRetransInterval
- The number of seconds between link-state advertisement retransmissions, for adjacencies belonging to this link. This value is also used when retransmitting database description and link-state request packets. This value should be well over th ...
- cospfShamLinkHelloInterval
- The length of time, in seconds, between the Hello packets that the router sends on the sham link.
- cospfShamLinkRtrDeadInterval
- The number of seconds that a router's Hello packets have not been seen before it's neighbors declare the router down. This should be some multiple of the Hello interval.
- cospfShamLinkState
- OSPF sham link states.
- cospfShamLinkEvents
- The number of state changes or error events on this sham link
- cospfShamLinkMetric
- The Metric to be advertised.
- cospfShamLinksTable
- Information about this router's sham links.
- cospfShamLinksEntry
- Information about a single sham link.
- cospfShamLinksAreaId
- The area that this sham link is part of.
- cospfShamLinksLocalIpAddrType
- The type of internet address of this sham link's local IP address.
- cospfShamLinksLocalIpAddr
- The Local IP address of the sham link.
- cospfShamLinksRemoteIpAddrType
- The type of internet address of this sham link's remote IP address.
- cospfShamLinksRemoteIpAddr
- The IP address of the other end router of the sham link.
- cospfShamLinksRetransInterval
- The number of seconds between link-state advertisement retransmissions, for adjacencies belonging to this link. This value is also used when retransmitting database description and link-state request packets. This value should be well over the expected ...
- cospfShamLinksHelloInterval
- The length of time, in seconds, between the Hello packets that the router sends on the sham link.
- cospfShamLinksRtrDeadInterval
- The number of seconds that a router's Hello packets have not been seen before it's neighbors declare the router down. This should be some multiple of the Hello interval.
- cospfShamLinksState
- OSPF sham link states.
- cospfShamLinksEvents
- The number of state changes or error events on this sham link
- cospfShamLinksMetric
- The Metric to be advertised.
- cospfShamLinkNbrTable
- A table of sham link neighbor information.
- cospfShamLinkNbrEntry
- Sham link neighbor information.
- cospfShamLinkNbrArea
- The area to which the sham link is part of.
- cospfShamLinkNbrIpAddrType
- The type of internet address of this sham link neighbor's IP address.
- cospfShamLinkNbrIpAddr
- The IP address this sham link neighbor is using.
- cospfShamLinkNbrRtrId
- A 32-bit integer uniquely identifying the neighboring router.
- cospfShamLinkNbrOptions
- A Bit Mask corresponding to the neighbor's options field. Bit 1, if set, indicates that the system will operate on Type of Service metrics other than TOS 0. If zero, the neighbor will ignore all metrics except the TOS 0 metric. Bit 2, if set, indic ...
- cospfShamLinkNbrState
- The state of this sham link neighbor relation- ship.
- cospfShamLinkNbrEvents
- The number of times this sham link has changed state or an error has occurred.
- cospfShamLinkNbrLsRetransQLen
- The current length of the retransmission queue. The retransmission queue is maintained for LSAs that have been flooded but not acknowledged on this adjacency.
- cospfShamLinkNbrHelloSuppressed
- Indicates whether Hellos are being suppressed to the neighbor.
- cospfLocalLsdbTable
- The OSPF Process's Link-Local Link State Database for non-virtual links.
- cospfLocalLsdbEntry
- A single Link State Advertisement.
- cospfLocalLsdbIpAddress
- The IP Address of the interface from which the LSA was received if the interface is numbered.
- cospfLocalLsdbAddressLessIf
- The Interface Index of the interface from which the LSA was received if the interface is unnumbered.
- cospfLocalLsdbType
- The type of the link state advertisement. Each link state type has a separate advertisement format.
- cospfLocalLsdbLsid
- The Link State ID is an LS Type Specific field containing a 32 bit identifier in IP address format; it identifies the piece of the routing domain that is being described by the advertisement.
- cospfLocalLsdbRouterId
- The 32 bit number that uniquely identifies the originating router in the Autonomous System.
- cospfLocalLsdbSequence
- The sequence number field is a signed 32-bit integer. It is used to detect old and duplicate link state advertisements. The space of sequence numbers is linearly ordered. The larger the sequence number the more recent the advertisement.
- cospfLocalLsdbAge
- This field is the age of the link state advertisement in seconds.
- cospfLocalLsdbChecksum
- This field is the checksum of the complete contents of the advertisement, excepting the age field. The age field is excepted so that an advertisement's age can be incremented without updating the checksum. The checksum used is the same that is used for IS ...
- cospfLocalLsdbAdvertisement
- The entire Link State Advertisement, including its header.
- cospfVirtLocalLsdbTable
- The OSPF Process's Link-Local Link State Database for virtual links.
- cospfVirtLocalLsdbEntry
- A single Link State Advertisement.
- cospfVirtLocalLsdbTransitArea
- The Transit Area that the Virtual Link traverses. By definition, this is not 0.0.0.0
- cospfVirtLocalLsdbNeighbor
- The Router ID of the Virtual Neighbor.
- cospfVirtLocalLsdbType
- The type of the link state advertisement. Each link state type has a separate advertisement format.
- cospfVirtLocalLsdbLsid
- The Link State ID is an LS Type Specific field containing a 32 bit identifier in IP address format; it identifies the piece of the routing domain that is being described by the advertisement.
- cospfVirtLocalLsdbRouterId
- The 32 bit number that uniquely identifies the originating router in the Autonomous System.
- cospfVirtLocalLsdbSequence
- The sequence number field is a signed 32-bit integer. It is used to detect old and duplicate link state advertisements. The space of sequence numbers is linearly ordered. The larger the sequence number the more recent the advertisement.
- cospfVirtLocalLsdbAge
- This field is the age of the link state advertisement in seconds.
- cospfVirtLocalLsdbChecksum
- This field is the checksum of the complete contents of the advertisement, excepting the age field. The age field is excepted so that an advertisement's age can be incremented without updating the checksum. The checksum used is the same that is used for IS ...
- cospfVirtLocalLsdbAdvertisement
- The entire Link State Advertisement, including its header.
- cospfLsdbGroup
- These objects are required for OSPF systems that display their link state database.
- cospfLocalLsdbGroup
- These objects are required for OSPF systems that display their Link-Local link state databases for non-virtual links.
- cospfVirtLocalLsdbGroup
- These objects are required for OSPF systems that display their Link-Local link state databases for virtual links.
- cospfBasicGroup
- These objects are required for OSPF systems.
- cospfAreaGroup
- These objects are required for OSPF systems supporting areas. This statement is recommended for use.
- cospfIfGroup
- These objects are required for OSPF systems.
- cospfVirtIfGroup
- These objects are required for OSPF systems.
- cospfShamLinkGroup
- These objects are required for OSPF systems.
- cospfShamLinkNbrGroup
- These objects are required for OSPF systems.
- cospfShamLinksGroup
- These objects are required for OSPF systems.
Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring network devices right now.
