CISCO-SWITCH-MULTICAST-MIB Download

cswmMvpnHwSwitchingStatus

Indicates the MVPN hardware switching status. 'notCapable' - This device is not capable of MVPN hardware switching 'enable' - MVPN hardware switching is enabled. 'disable' - MVPN hardware switching is disabled.

cswmVrfLiteStatus

Indicates the VRF-Lite switching status. 'notCapable' - This device is not capable of VRF-Lite switching. 'enable' - VRF-Lite switching is enabled. 'disable' - VRF-Lite switching is disabled.

cswmMRouteConsistCheck

Specifies the Multicast Routing(mroute) Table consistency checker support mode. The consistency checker scans the mroute table and assures that multicast-hardware entries are consistent with mroute table. 'notCapable' - This device is not capable of mr ...

cswmProcessorConsistCheck

Specifies the Processor consistency checker support mode. In a multiple processor device, the consistency checker assures that multicast flow entries are consistent across processors. Example: In a Catalyst 6000 series device, which has a Route Processor ...

cswmReplCapabilityTable

A table containing multicast replication capability information.

cswmReplCapabilityEntry

A conceptual row of cswmReplCapabilityTable, containing the multicast replication capability information for per module (identified by entPhysicalIndex) per Internet address type supported on the managed system. An entry is created by the agent at the sys ...

cswmReplCapability

Indicates the multicast replication capability. The replication capability of a module for a particular address type is dependent on the hardware and software capabilities of the module.

cswmReplConfigTable

A table containing multicast flow replication information for the device.

cswmReplConfigEntry

A conceptual row of cswmReplConfigTable, containing multicast flow replication information.

cswmReplConfigAddrType

The Internet address type supporting multicast flow replication.

cswmReplConfigCurMode

Specifies the current mode of multicast flow replication for this address type. 'notCapable' - This device is not capable of Multicast flow replication for this address type. 'ingress' - The current mode of replication is ingress. 'egressAn ...

cswmReplConfigAutoDetect

Specifies the auto-detection of multicast replication mode for this address type. 'notCapable' - This device is not capable of Auto-detection of multicast replication mode for this address type. 'enable' - The auto-detection of multicast replication ...

cswmGlobalReplcationMode

Specifies the current mode of multicast flow replication for all Internet address types supporting multicast flow replication. 'notCapable' - This device is not capable of Multicast flow replication. 'ingress' - The current mode of replication is ing ...

cswmMvrfStatsTable

A table containing multicast flow statistics information on each Multicast VPN routing/forwarding instance (MVRF).

cswmMvrfStatsEntry

A conceptual row of cswmMvrfStatsTable, containing multicast flow statistics for each MVRF.

cswmMvrfName

The human-readable name of this VPN.

cswmMvrfTotalFlows

Indicates the total number of multicast flow entries installed for this MVRF.

cswmMvrfPartialFlows

Indicates the total number of multicast partial short cut flow entries installed for this MVRF.

cswmMvrfRpfMfdFlows

Indicates the total number of Reverse Path Forwarding(RPF) Multicast Fast Drop(MFD) flow entries installed for this MVRF.

cswmBiDirPimDfUsed

The number of Bi-directional PIM Designated Forwarder entries currently in use by the default MVRF on the device.

cswmBiDirPimDfTotal

The total number of Bi-directional PIM Designated Forwarder entries for the default MVRF on the device.

cswmMvrfBiDirPimDfUsageTable

A table containing multicast Bi-directional PIM Designated Forwarder usage information on each Multicast VPN routing/forwarding instance (MVRF) for every Internet address type supported.

cswmMvrfBiDirPimDfUsageEntry

A conceptual row of cswmMvrfBiDirPimDfUsageTable, containing multicast Bi-directional PIM Designated Forwarder usage information on each MVRF per Internet address type.

cswmMvrfBiDirPimDfAddrType

This object indicates the internet address type for which the multicast Bi-directional PIM Designated Forwarder usage information is collected.

cswmMvrfBiDirPimDfUsed

The number of Bi-directional PIM Designated Forwarder entries currently in use.

cswmMvrfBiDirPimDfTotal

The total number of Bi-directional PIM Designated Forwarder entries.

cswmLtlUsed

This object indicates the number of Multicast LTL entries currently used by this device.

cswmLtlTotal

This object indicates the total number of Multicast LTL entries available for this device.

cswmForwardingTable

A table containing multicast forwarding information.

cswmForwardingEntry

A conceptual row of cswmForwardingTable, containing multicast forwarding information on a particular interface for every Internet address type supported.

cswmInterfaceIndex

This object specifies the ifIndex for interface capable of performing forwarding.

cswmForwardingAddrType

This object specifies the internet address type of the multicast forwarding.

cswmForwardingEnabled

This object specifies whether multicast forwarding is supported on this interface for a particular internet address type. 'notCapable' - A read-only value which indicates that this interface is not capable of multicast forwarding for this internet addr ...

cswmFlowMaxQueries

Maximum number of query entries allowed to be outstanding at any time, in the cswmFlowQueryTable. The typical value for this object is 5.

cswmFlowQueryTable

A control table used to query the switching engine by specifying retrieval criteria for IP multicast L3 flows. Each row instance in the table represents a query with its parameters. The resulting per-flow data if requested for each instance of a query in ...

cswmFlowQueryEntry

A conceptual row of the cswmFlowQueryTable used to setup retrieval criteria to search for IP multicast L3 flows on a switching engine entity in the device.

cswmFlowQueryIndex

An arbitrary integer in the range of 1 to cswmFlowMaxQueries to identify this control query.

cswmFlowQueryMask

This object is used to set up the query criteria for the multicast flows of interest. If any one of the defined BITs is set, then the objects(s) corresponding to the BITS in the same row instance will be used for the search. Specifically, if the 'vrf' BI ...

cswmFlowQueryMvrf

The human-readable name of the Multicast Virtual Private Network (MVPN) routing/forwarding instance (MVRF). When the 'mvrf' bit of cswmFlowQueryMask object in the same row is on, an appropriate value should be specified and only flows with the specified M ...

cswmFlowQueryAddrType

The Internet address type for this multicast search query.

cswmFlowQuerySource

The source Internet address of the IP multicast layer 3 flows. When the 'source' BIT of cswmFlowQueryMask object in the same row is on, an appropriate value should be specified and only flows with the specified source address will be contained in the resu ...

cswmFlowQueryGroup

The multicast group Internet address of the queried flows. When the 'group' or 'groupmask' bit of cswmFlowQueryMask object in the same row is on, an appropriate value should be specified and only flows with the specified group address will be contained i ...

cswmFlowQueryGroupMask

The length of the Prefix associated with cswmFlowQueryGroup. When the 'groupmask' bit of cswmFlowQueryMask object in the same row is on, an appropriate value should be specified and only rows with the specied group address prefix will be returned in the r ...

cswmFlowQueryType

This object is used to set up the query type for the multicast flows of interest. If the 'perFlow' BIT is set, then, the entries matching this query will be returned in in cswmFlowResultTable. If the 'perFlow' BIT is not set, then only the total number of ...

cswmFlowQueryEntityIndex

This object identifies the switching engine for which the query is issued. When the value of this object is 0, the query is performed on the switching engine of the active supervisor.

cswmFlowQuerySkipNFlows

The number of searched flows to be skipped before storing any multicast flows in cswmFlowResultTable, when the 'perFlow' bit is set in cswmFlowQueryType. This object can be used along with cswmFlowMcastQueryMoreRows object to skip previously found flows a ...

cswmFlowQueryTotalFlows

The number of flows matching the query criteria. The value of this object will be zero when the 'perFlow' bit is set in cswmFlowQueryType.

cswmFlowMcastQueryRows

Indicating the status of the query by following values: -1 - Either the query has not been started or the agent is still processing this query instance. It is the default value when the row is instantiated. 0..2147483647 - The search has ended and this is ...

cswmFlowMcastQueryMoreRows

If the value of the object is true when there are more entries available matching this query criteria, than the ones returned in cswmFlowResultTable.

cswmFlowQueryOwner

The manager entity that configured this entry and is therefore using the resources assigned to it. It is used to model an administratively assigned name of the owner of a resource. It is recommended that this object have one or more the following informa ...

cswmFlowQueryCreateTime

Time when this query was created.

cswmFlowQueryStorage

The storage type for this conceptual row.

cswmFlowQueryStatus

The status object used to manage rows in this table. When set to 'active', the query to search for l3 multicast flows is initiated. Once a row becomes active, values within the row cannot be modified, except by deleting and re-creating the row.

cswmFlowResultTable

A table containing current IP multicast flow information corresponding to all the completed queries set up in the cswmFlowQueryTable, that were initiated on the switch engine(s) with the 'perFlow' bit set in cswmFlowQueryType. The query result will not be ...

cswmFlowResultEntry

A conceptual row of cswmFlowResultTable, containing information about an IP multicast layer 3 flow that matchs the search criteria set in the corresponding row of cswmFlowQueryTable. This row instance is indexed by the query index (cswmFlowQueryIndex), a ...

cswmFlowResultIndex

A positive integer which uniquely identify a result entry matching a particular query.

cswmFlowResultMvrf

The MVRF to which this flow belongs to.

cswmFlowResultAddrType

The Internet address type of cswmFlowResultGroup, cswmFlowResultGroupMask and cswmFlowResultSource.

cswmFlowResultGroup

The group address of the multicast layer 3 flow.

cswmFlowResultGroupMask

The length of the Prefix associated with cswmFlowResultGroup. A value of zero causes all addresses to match. This prefix length will be consistent with the type specified in cswmFlowResultAddrType.

cswmFlowResultSource

The source address of the multicast layer 3 flow.

cswmFlowResultFlags

This object indicates the corresponding flags for this flow: 'copy' - indicates that traffic is copied to CPU and forwarded in hardware. 'punt' - indicates that traffic is punted to CPU and forwarded in software. 'ineligible' - indicates that ...

cswmFlowResultRpfInterface

This object represents either the InterfaceIndex of RPF interface for a RPF flow or 0 (zero). The value of zero means that this flow is a non-RPF flow.

cswmFlowResultPackets

The total number of multicast traffic packets forwarded for this flow.

cswmFlowResultOctets

The total number of multicast traffic octets forwarded for this flow.

cswmFlowResultOIFTable

A table containing list of OIF for a flow listed in cswmFlowResultTable.

cswmFlowResultOIFEntry

A conceptual row of cswmFlowResultOIFTable, containing information about the list of OIF for a flow listed in cswmFlowResultTable. An entry is created only when the 'oifList' bit is set in cswmFlowQueryType.

cswmFlowResultOIFIndex

A positive integer which uniquely identifies a list of OIF for a particular result flow matching a particular query.

cswmFlowResultOIFIntList

The object lists the ifIndex for a set of 64 OIF for a particular flow.

cswmFlowResultDFTable

A table containing list of DF interfaces for a flow listed in cswmFlowResultTable.

cswmFlowResultDFEntry

A conceptual row of cswmFlowResultDFTable, containing information about the list of DF Interfaces for a flow listed in cswmFlowResultTable. An entry is created only when the 'dfList' bit is set in cswmFlowQueryType.

cswmFlowResultDFIndex

A positive integer which uniquely identifies a list of DF interfaces for a particular flow matching a particular query.

cswmFlowResultDFIntList

The object lists the ifIndex for a set of 64 DF interfaces for a particular flow.

cswmGlobalGroup

A collection of objects providing global multicast information and configuration.

cswmConsistCheckGroup

A collection of objects providing multicast consitency check information and configuration.

cswmReplicationGroup

A collection of objects providing multicast replication information and configuration.

cswmMvrfStatsGroup

A collection of objects providing MVRF statistics.

cswmBiDirPimDfUsageGroup

A collection of objects providing Bi-directional PIM Designated Forwarder database Usage information.

cswmLtlUsageGroup

A collection of objects providing Multicast LTL usage information.

cswmGlobalReplicationGroup

A collection of objects providing multicast global replication information and configuration.

cswmMvrfBiDirPimDfUsageGroup

A collection of objects providing Bi-directional PIM Designated Forwarder database Usage information for each MVRF available on the device.

cswmForwardingGroup

A collection of objects providing multicast forwarding information and configuration.

cswmFlowQueryResultGroup

A collection of objects for querying l3 multicast flows.