DOCS-MCAST-MIB Download
This MIB module contains the management objects for the
management of Multicast over DOCSIS to support Multicast
DSID forwarding and or bonded multicast.
IPHost Network Monitor offer an easy way of SNMP monitoring your Cisco Servers, Routers, Switches, Bridges,
Firewalls, Repeaters.
OID list for DOCS-MCAST-MIB
- docsMcastCmtsGrpCfgTable
- This object controls the QoS, PHS and encryption settings for downstream forwarding of IP multicast sessions. An IP multicast session is replicated to one or more Downstream Channel Sets (DCSs), where each DCS is either a single downstream channel or a do ...
- docsMcastCmtsGrpCfgEntry
- The conceptual row of docsMcastCmtsGrpCfg. The CMTS persists all instances of the CmtsGrpConfig object across system reinitializations.
- docsMcastCmtsGrpCfgId
- This attribute represents the unique identifier of instances of this object. This attribute is the key that identifies unique instances of the CmtsGrpConfig object.
- docsMcastCmtsGrpCfgRulePriority
- This attribute indicates the priority of this entry used to resolve which instance of this object apply when a newly replicated multicast session matches multiple entries. Higher values indicate a higher priority. Valid values for this attribute are 0..63 ...
- docsMcastCmtsGrpCfgPrefixAddrType
- This attribute identifies the address family for the multicast session (S,G) of the GC which corresponds to the SrcPrefixAddr and GrpPrefixAddr attributes respectively.
- docsMcastCmtsGrpCfgSrcPrefixAddr
- This attribute defines the IP source address prefix of the IP multicast session. Source prefix addresses are unicast host addresses.
- docsMcastCmtsGrpCfgSrcPrefixLen
- This attribute identifies the prefix of a range of Source (S) IP multicast group addresses. For Group or ASM based sessions this attribute is set to 0.
- docsMcastCmtsGrpCfgGrpPrefixAddr
- This attribute identifies the prefix of a range of destination IP multicast group addresses.
- docsMcastCmtsGrpCfgGrpPrefixLen
- This attribute identifies the prefix of a range of IP multicast group addresses.
- docsMcastCmtsGrpCfgTosLow
- This attribute identifies the low value of a range of the TOS byte value to be defined in a packet classifier this GC instantiates in the GCR in order to limit the GCR-matched traffic to a particular set of DSCPs. This applies to the IPv4 TOS byte and th ...
- docsMcastCmtsGrpCfgTosHigh
- This attribute identifies the high value of a range of the TOS byte value to be defined in a packet classifier this GC instantiates in the GCR in order to limit the GCR-matched traffic to a particular set of DSCPs. This applies to the IPv4 TOS byte and t ...
- docsMcastCmtsGrpCfgTosMask
- This attribute identifies the mask value bitwise ANDed with a TOS byte value to be defined in a packet classifier this GC instantiates in the GCR in order to limit the GCR-matched traffic to a particular set of DSCPs. This applies to the IPv4 TOS byte and ...
- docsMcastCmtsGrpCfgQosConfigId
- This attribute identifies an instance in CmtsGrpQosCfg for configuring the QoS for the replication of the sessions matching this CmtsGrpCfg instance. The value 0 indicates that all replications referenced by this CmtsGrpCfg instance will be forwarded to t ...
- docsMcastCmtsGrpCfgEncryptConfigId
- This attribute identifies an instance in CmtsGrpEncryptionCfg for configuring the encryption of replicationsderived from this GC. The value 0 indicates no encryption for all replications derived from this GC.
- docsMcastCmtsGrpCfgPhsConfigId
- This attribute identifies an instance in CmtsGrpPhsCfg that configures DSID-indexed PHS compression for all replications derived from this GC. The value 0 indicates no PHS compression for all replications derived from this GC.
- docsMcastCmtsGrpCfgRowStatus
- The status of this instance.
- docsMcastCmtsGrpEncryptCfgTable
- This object controls the configuration of the Security Association (SA) and the encryption algorithm used for multicast sessions. This object supports the creation and deletion of instances.
- docsMcastCmtsGrpEncryptCfgEntry
- The conceptual row of docsMcastCmtsGrpEncryptCfg. The CMTS persists all instances of the CmtsGrpEncryptionConfig object across system reinitializations.
- docsMcastCmtsGrpEncryptCfgId
- This attribute specifies the unique identifier of instances of this object
- docsMcastCmtsGrpEncryptCfgCtrl
- This attribute controls whether the CMTS can select the encryption algorithm or if this can be set manually using the Alg attribute. If this attribute is set to 'cmts', the CMTS can select the encryption algorithm for the Security Association (SA). If t ...
- docsMcastCmtsGrpEncryptCfgAlg
- This attribute defines which encryption algorithm will be used for an SA referenced by this object when the Ctrl is set to 'mgmt'.
- docsMcastCmtsGrpEncryptCfgRowStatus
- The status of this instance.
- docsMcastCmtsGrpPhsCfgTable
- This object controls the configuration of DSID-indexed PHS for multicast sessions. Configuration of PHS Rules via this table must not be based on the configuration of a range of sessions, but must be configured on a single multicast session. Creation of m ...
- docsMcastCmtsGrpPhsCfgEntry
- The conceptual row of docsMcastCmtsGrpPhsCfg. The CMTS persists all instances of the CmtsGrpPhsConfig object across system reinitializations.
- docsMcastCmtsGrpPhsCfgId
- This attribute identifies the unique identifier of a PHS rule that is referenced by the GrpConfig object.
- docsMcastCmtsGrpPhsCfgPhsField
- This attribute defines the bytes of the DOCSIS header which must be suppressed/restored by the sending/receiving device.
- docsMcastCmtsGrpPhsCfgPhsMask
- This attribute defines the bit mask which is used in combination with the PhsField to define which bytes in header must be suppressed/restored by the sending or receiving device. Each bit of this bit mask corresponds to a byte in the PhsField, with the l ...
- docsMcastCmtsGrpPhsCfgPhsSize
- This attribute specifies the number of bytes in the header to be suppressed and restored. The value of this object matches the number of bytes the bits indicated in the PhsField attribute.
- docsMcastCmtsGrpPhsCfgPhsVerify
- This attribute specifies the Payload Header Suppression verification value of 'true' the sender must verify PhsField is the same as what is contained in the packet to be suppressed.
- docsMcastCmtsGrpPhsCfgRowStatus
- The status of this instance.
- docsMcastCmtsGrpQosCfgTable
- This object configures the QoS configured for Multicast sessions replicated to any Downstream Channel Set. It does not control which particular DCSs to which the CMTS replicates a multicast session. An instance in this object is called a GQC entry. A GQC ...
- docsMcastCmtsGrpQosCfgEntry
- The conceptual row of docsMcastCmtsGrpQosCfg. The CMTS persists all instances of the CmtsGrpQosConfig object across system reinitialization.
- docsMcastCmtsGrpQosCfgId
- This attribute identifies a unique Group QoS Configuration object instance.
- docsMcastCmtsGrpQosCfgServiceClassName
- This attribute identifies the Service Class Name reference for the set of QoS parameters for this GQC.
- docsMcastCmtsGrpQosCfgQosCtrl
- This attribute identifies how Group Classifier Rules (GCRs) and Group Service Flows (GSFs) are instantiated when multiple sessions match the (S,G) criteria of this entry. If 'singleSession', the CMTS creates a unique GCR and a unique GSF for the session. ...
- docsMcastCmtsGrpQosCfgAggSessLimit
- This attribute identifies the maximum number of sessions that may be aggregated in an aggregated Service Flow. This value is ignored in case of a GQC entry with QosCtrl set to 'singleSession'.
- docsMcastCmtsGrpQosCfgAppId
- This attribute configures an application identifier that an operator configures to enable special features for QoS admission control or other policies. The behavior and usage of the Application dentifier is vendor specific. This attribute allows the opera ...
- docsMcastCmtsGrpQosCfgRowStatus
- The status of this instance.
- docsMcastCmtsReplSessTable
- This object describes the replication of IP Multicast sessions onto the different Downstream Channel Sets of a CMTS. Each DCS may be either a single downstream channel or a bonding group of multiple downstream channels. Each IP Multicast session is ident ...
- docsMcastCmtsReplSessEntry
- The conceptual row of docsMcastCmtsReplSess.
- docsMcastCmtsReplSessPrefixAddrType
- This atrribute defines the address type for the GrpPrefix and SrcPrefix addresses.
- docsMcastCmtsReplSessGrpPrefix
- This attribute defines the group G of a particular (S,G) IP multicast session.
- docsMcastCmtsReplSessSrcPrefix
- This attribute identifies a specific Multicast Source Address. A Source Address that is all zeros is defined as 'all source addresses (*, G)'.
- docsMcastCmtsReplSessMdIfIndex
- This attribute defines the MAC Domain Interface index of the channel to which the (S,G) session is replicated.
- docsMcastCmtsReplSessDcsId
- This attribute provides the reference for the Downstream Channel Set within a MAC Domain that the multicast session (S,G) is replicated to.
- docsMcastCmtsReplSessServiceFlowId
- This attribute indicates the service flow into which packets are classified for this replication of the multicast session (S,G).
- docsMcastCmtsReplSessDsid
- This attribute defines the Downstream Service ID (DSID) label with which the CMTS labels all packets of the (S,G) session on the DCS of a MAC Domain. The DSID value is unique per MAC domain.
- docsMcastCmtsReplSessSaid
- This attribute defines the Security Association ID (SAID) of this multicast replication session. The value 0 indicates no SAID assocated with this session.
- docsMcastDefGrpSvcClassDef
- This attribute references an instance of the SNMP table docsIetfQosServiceClassName object. This attribute is used to expand the QoS parameter Set of QoS for multicast sessions that uses a default QoS policy. The CMTS persists all instances of this attrib ...
- docsMcastDsidPhsTable
- This object reports the set of DSID-Indexed PHS rules that are signaled between the CMTS and CMs as part of the Multicast Sessions setup. The attributes PhsMask, PhsSize and PhsVerify comes from the configuration object CmtsGrpPhsCfg. The value of the Ph ...
- docsMcastDsidPhsEntry
- The conceptual row of docsMcastDsidPhs. The ifIndex key corresponds to the MAC Domain interface where the PHSI-Indexed DSID is configured.
- docsMcastDsidPhsDsid
- This attribute represents the 20-bit DSID associated with this PHS rule.
- docsMcastDsidPhsPhsField
- This attribute defines the bytes of the header which must be suppressed/restored by the sending/receiving device.
- docsMcastDsidPhsPhsMask
- This attribute defnes the Payload Header Suppression mask in the header to be suppressed and restored.
- docsMcastDsidPhsPhsSize
- This attribute defines the the number of bytes in the header to be suppressed and restored.
- docsMcastDsidPhsPhsVerify
- This attribute, when set to 'true', indicates that the sender must verify that the PHS Field attribute value is the same is the same as what is contained in the packet to be suppressed.
- docsMcastGroup
- Group of objects implemented in the CMTS.
Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring network devices right now.