lsPerVcqRmHierarchicalSchedulingMode - Lightstream Per VC Queueing Rm Hierarchical Scheduling Mode - CISCO-ATM-RM-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

lsPerVcqRmHierarchicalSchedulingMode

Lightstream Per VC Queueing Rm Hierarchical Scheduling Mode
1.3.6.1.4.1.9.10.10.1.7.3

On a LS1010 equipped with the Lightstream per-VC queueing chipset, the user can define Hierarchical VP-Tunnels. Each such tunnel has its own dedicated scheduler, programmed to output data at a configurable maximum rate. Therefore, the overall output of the Hierarchical VP-tunnel is rate-limited. In addition, Virtual Circuits of different service categories can traverse through such a tunnel, and each of these Virtual Circuits are guaranteed their individual contracted bandwidth agreement. This object must be set to enabled before any Hierarchical VP-tunnels can be defined on the device. Any setting of this variable requires a reload of the device to be effective. Setting this object to enabled will cause the software to initialize the additional schedulers needed by the Hierarchical VP-Tunnels. Other limited scheduler resources are therefore used by a larger number of schedulers (as compared to the case when Hierarchical Scheduling is disabled on the device). This may result in fewer number of connections passing Connection Admission Control. This object is therefore provided so that the user can make an informed decision as to whether Hierarchical Scheduling is to be used. This object is defined on a LS1010 only when the switch is equipped with the Lightstream per-VC queueing chipset.

Back to CISCO-ATM-RM-MIB MIB page.

IPHost Network monitor allows you to monitor lsPerVcqRmHierarchicalSchedulingMode on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco firewalls right now.

Easy monitoring of lsPerVcqRmHierarchicalSchedulingMode with IPHost tools

MIBs list