CISCO-MGX82XX-DSX1-MIB - lineLoopbackCommand

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

lineLoopbackCommand

line Loopback Command
1.3.6.1.4.1.351.110.4.3.1.1.1.1.8

This variable represents the loopback confi- guration of the DS1 interface. Agents support- ing read/write access should return badValue in response to a requested loopback state that the interface does not support. The values mean: dsx1NoLoop Not in the loopback state. A device that is not capable of performing a loopback on the interface shall always return this as it's value. dsx1RemoteLoop The received signal at this interface is looped through the device. Typically the received signal is looped back for retransmission after it has passed through the device's framing function. dsx1LocalLoop The local data is looped back dsx1PayloadLoop This will loop only the payload and not framing/sync bit. DEFVAL {dsx1NoLoop} ::= { dsx1CnfGrpEntry 8 } SYNTAX INTEGER { dsx1SendNoCode (1), dsx1SendLineCode (2), dsx1SendPayloadCode (3), dsx1SendResetCode (4) } MAX-ACCESS read-write STATUS current DESCRIPTION This variable indicates what type of code is being sent across the DS1 interface by the dev- ice. The values mean: dsx1SendNoCode sending looped or normal data dsx1SendLineCode sending a request for a line loopback dsx1SendPayloadCode sending a request for a payload loopback dsx1SendResetCode sending a loopback termination request DEFVAL {dsx1SendNoCode} ::= { dsx1CnfGrpEntry 9 } SYNTAX Integer32(0..2147483647) MAX-ACCESS read-only STATUS current DESCRIPTION Bit map of used DS0 for this line.

Back to CISCO-MGX82XX-DSX1-MIB MIB page.

IPHost Network monitor allows you to monitor lineLoopbackCommand on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco optical switches right now.

Easy monitoring of lineLoopbackCommand with IPHost tools

MIBs list