With IPHost Network Monitor you can run simple snmp requests against a D-Link device in your network.
swL2FilterAddrState
Switch L2 Filter Address State
1.3.6.1.4.1.171.11.70.5.2.6.3.1.3
This object indicates the status of this entry. other(1) - this entry is currently in use but the conditions under which it will remain so are different from each of the following values . dst-addr(2) - recieved frames's destination address are currently used to be filtered as it meets with the MAC address entry of the table . src-addr(3) - recieved frames's source address are currently used to be filtered as it meets with the MAC address entry of the table . dst-src-addr(4) - recieved frames's destination address or source address are currently used to be filtered as it meets with the MAC address entry of the table . invalid(5) - writing this value to the object, and then the corresponding entry will be removed from the table .
Back to DHS3224-MIB MIB page.
IPHost Network monitor allows you to monitor swL2FilterAddrState on D-Link device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring D-Link IP cameras right now.