With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.
rprIfStatsControlValidIntervals
rpr If Stats Control Valid Intervals
1.0.8802.17.1.1.1.1.2.1.7
The number of previous 15-minute intervals for which data was collected. An RPR interface must be capable of supporting at least n intervals. The minimum value of n is 4. The default of n is 32. The maximum value of n is 96. The value will be unless the measurement was (re-)started within the last (*15) minutes, in which case the value will be the number of complete 15 minute intervals for which the agent has at least some data. In certain cases (e.g., in the case where the agent is a proxy) it is possible that some intervals are unavailable. In this case, this interval is the maximum interval number for which data is available.
Back to IEEE-802DOT17-RPR-MIB MIB page.
IPHost Network monitor allows you to monitor rprIfStatsControlValidIntervals on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco mobile switches right now.
