OIDs - Phase monitor
The objects described here can be monitored with the IPHost Network Monitor.
You can start SNMP monitoring using free 30-day trial version of IPHost right now.
OID list for phase
- Frame Relay Interface Vc Control Compression Operation Phase
- frxVcControlCompressionOperPhase 1.3.6.1.4.1.800.2.8.2.1.1.5 (defined in XYLAN-FRAME-RELAY-MIB)
This object reports the current phase (state) of compression for this virtual circuit if the Compression Admin Status is set to enable. If the compression Admin status is set to disabled, then this object will report as disabled. Otherwise the value reflects whether compression is currently inactive or failed negotiation (disabled) is under negotiation (initialization) or active (operation). Possible causes of disabled are a failed negotiation, virtual circuit inactive, the other side not supporting compression, etc. For a description of the phases (states), see Frame Relay Forum Implementation aggreement on Data Compression (FRF.9) - qsim Port Receive Timing Phase
- qsimPortReceiveTimingPhase 1.3.6.1.4.1.43.1.12.3.1.1.12.2.1.1.4 (defined in 3comab9300)
Receive timing phase control. This object applies ONLY when a DCE cable is connected to the port. If cable type is 'none' or 'dce', this object can be read and written. If cable type is 'dte', a get request returns whatever value currently stored in the managed node for this port and a set request returns genErr. - cbr V35 Port Configuration Tx Clock Phase
- cbrV35PortConfTxClockPhase 1.3.6.1.4.1.43.1.12.3.1.1.15.5.1.1.3 (defined in 3comab9300)
This object indicates the type of Transmit clock phase needed to correct the clock out of phase problem. This is aplicable ONLY when a 'dte' cable is connected to the port. The default value is normal (1). - Compaq Scsi Target Phase Errors
- cpqScsiTargetPhaseErrs 1.3.6.1.4.1.232.5.2.5.1.1.9 (defined in CPQSCSI)
Compaq SCSI Device Bus Phase Errors. This is the number of times the SCSI bus entered an invalid operating state while processing commands for the SCSI ID. This value is maintained since the SCSI Hardware Interface driver was loaded. If you see any phase errors you may have a problem. Phase errors can be caused by a device which is not operating correctly. If the phase errors continue to increase the device should be replaced. - Compaq Sb Device Phase Errors
- cpqSbDevPhaseErrs 1.3.6.1.4.1.232.7.2.2.1.9 (defined in CPQSCSI)
Compaq SCSI Device Bus Phase Errors This is the number of times the SCSI bus entered an invalid operating state while processing commands for the SCSI ID since the SCSI Hardware Interface driver was loaded. If you see any phase errors you may have a problem. Phase errors can be caused by a device which is not operating correctly. If the phase errors continue to increase the device should be replaced. - Cisco PDSN Cdma Ext Pcf Service Option Ppp Lcp Phase Rx Termreqs
- ccpCdmaExtPcfSoPppLcpPhaseRxTermreqs 1.3.6.1.4.1.9.9.669.1.2.7.1.1.6 (defined in CISCO-CDMA-PDSN-EXT-MIB)
This object indicates total number of PPP negotiations terminated per PCF due to PPP receiving TERM request during the LCP phase. - Cisco PDSN Cdma Ext Pcf Service Option Ppp Authentication Phase Rx Termreqs
- ccpCdmaExtPcfSoPppAuthPhaseRxTermreqs 1.3.6.1.4.1.9.9.669.1.2.7.1.1.12 (defined in CISCO-CDMA-PDSN-EXT-MIB)
This object indicates total number of PPP negotiations terminated per PCF due to PPP receiving TERM request during the authentication phase. - Cisco PDSN Cdma Ext Pcf Service Option Ppp Ipcp Phase Rx Termreqs
- ccpCdmaExtPcfSoPppIpcpPhaseRxTermreqs 1.3.6.1.4.1.9.9.669.1.2.7.1.1.17 (defined in CISCO-CDMA-PDSN-EXT-MIB)
This object indicates total number of PPP negotiations terminated per PCF due to PPP receiving TERM request during the IPCP phase. - Cisco Cdma Ppp Ipcp Phase Received Termreqs
- cCdmaPppIpcpPhaseReceivedTermreqs 1.3.6.1.4.1.9.9.157.1.7.3.1.21 (defined in CISCO-CDMA-PDSN-MIB)
Total number of PPP negotiations terminated due to PPP receiving term request during the IPCP phase. - Cisco Cdma Ppp Ipcp Phase Sent Termreqs
- cCdmaPppIpcpPhaseSentTermreqs 1.3.6.1.4.1.9.9.157.1.7.3.1.22 (defined in CISCO-CDMA-PDSN-MIB)
Total number of PPP negotiations terminated due to PPP sending term request during the IPCP phase. - Cisco Cdma Ppp Authentication Phase Received Termreqs
- cCdmaPppAuthPhaseReceivedTermreqs 1.3.6.1.4.1.9.9.157.1.7.3.1.23 (defined in CISCO-CDMA-PDSN-MIB)
Total number of PPP negotiations terminated due to PPP receiving term request during the authentication phase. - Cisco Cdma Ppp Authentication Phase Sent Termreqs
- cCdmaPppAuthPhaseSentTermreqs 1.3.6.1.4.1.9.9.157.1.7.3.1.24 (defined in CISCO-CDMA-PDSN-MIB)
Total number of PPP negotiations terminated due to PPP sending term request during the authentication phase. - Cisco Cdma Ppp Lcp Phase Received Termreqs
- cCdmaPppLcpPhaseReceivedTermreqs 1.3.6.1.4.1.9.9.157.1.7.3.1.25 (defined in CISCO-CDMA-PDSN-MIB)
Total number of PPP negotiations terminated due to PPP receiving term request during the LCP phase. - Cisco Cdma Ppp Lcp Phase Sent Termreqs
- cCdmaPppLcpPhaseSentTermreqs 1.3.6.1.4.1.9.9.157.1.7.3.1.26 (defined in CISCO-CDMA-PDSN-MIB)
Total number of PPP negotiations terminated due to PPP sending term request during the LCP phase. - Cisco Crypto Accelerator Protocol Next Phase Key Allocation Requests
- ccaProtNextPhaseKeyAllocReqs 1.3.6.1.4.1.9.9.467.1.2.3.1.1.10 (defined in CISCO-CRYPTO-ACCELERATOR-MIB)
The number of times requests for allocation of keys for the next phase of the protocol operation which were received by the crypto accelerators from this security protocol, counted since the last reboot of the device. As an example, for IKE, this would identify the number of times key allocation requests for Quick Mode were received by the crypto accelerator from the IKE protocol engine.