The objects described here can be monitored with the IPHost Network Monitor.
You can start SNMP monitoring using free 30-day trial version of IPHost right now.
OID list for response time
- igmp Snoop Query Max Response Time
- igmpSnoopQueryMaxResponseTime 1.3.6.1.4.1.43.10.37.1.5 (defined in A3COM0073IGMP-SNOOP)
The maximum query response time in seconds advertised in IGMP v2 queries on this VLAN if the switch is the querier. Smaller values allow a switch to prune groups faster. So it is the maximum response time inserted into the general periodic queries. This variable enables the tuning of the burstiness of the IGMP traffic. If it is increased the responses have a larger time span in which to be generated by the hosts. It is set stack-wide. The default is 10 seconds and the range is 10 to 100 seconds. There could be 2 settings apart from the default. Slow Response (50 secs) and Very Slow Response (100 secs). - a3 Com Poll Response Time Out
- a3ComPollResponseTimeOut 1.3.6.1.4.1.43.29.4.22.1.1.7 (defined in A3COM-SWITCHING-SYSTEMS-POLL-MIB)
Maximum wait time, in msecs, for a response packet before deciding that no response arrived. This object differs from a3ComPollRate as the device have the sending and receiving queues independent, making it possible to send ping requests at rates faster than receiving. The value of 0 (default) will be interpreted as a request for time-out by the time a new packet is sent, and 65535 as a request for maximum wait. Assuming that burst is used and this object is set to one, most likely all packets sent will be interpreted as timed out. This object may not be modified if the associated a3ComPollReport is equal to busy(2). When this object is successfully set, a3ComPollReport will be set to idle(1). - atm LAN Emulation Client Expected Arp Response Time
- atmLecExpectedArpResponseTime 1.3.6.1.4.1.800.2.4.8.1.1.18 (defined in XYLAN-ATM-MIB)
C20 Expected LE_ARP Reponse Time. The maximum time that the LEC expects an LE_ARP_REQUEST/ LE_ARP_RESPONSE cycle to take. Used for retries and verifies. This time value is expressed in seconds. - xylan AVL Ldap Response Time
- xylanAVLLdapResponseTime 1.3.6.1.4.1.800.2.15.1.28.1.8 (defined in XYLAN-AVL-MIB)
LDAP server response time in seconds. - sna Lu Rtm Last Response Time
- snaLuRtmLastRspTime 1.3.6.1.2.1.34.1.3.1.1.18 (defined in rfc1666)
This value indicates the response time for the last transaction in units of 1/10th of a second. - sna Lu Rtm Average Response Time
- snaLuRtmAvgRspTime 1.3.6.1.2.1.34.1.3.1.1.19 (defined in rfc1666)
This value indicates the average response time for all transactions in units of 1/10th of a second. - Cabletron IGMP Vlan Query Max Response Time
- ctIGMPVlanQueryMaxResponseTime 1.3.6.1.4.1.52.4.1.3.5.1.2.1.6 (defined in ctron-igmp-mib)
The maximum query response time advertised in IGMPv2 queries on this Vlan. - sfps Resolve Statistics Average Response Time
- sfpsResolveStatsAvgResponseTime 1.3.6.1.4.1.52.4.2.4.2.2.2.4.1.3.8 (defined in ctron-sfps-resolve-mib)
- sfps Resolve Statistics Max Response Time
- sfpsResolveStatsMaxResponseTime 1.3.6.1.4.1.52.4.2.4.2.2.2.4.1.3.30 (defined in ctron-sfps-resolve-mib)
- sfps Mobility Statistics Average Response Time
- sfpsMobilityStatsAvgResponseTime 1.3.6.1.4.1.52.4.2.4.2.2.9.2.3.50 (defined in ctron-sfps-resolve-mib)
(msec) - igmp Snoop Query Max Response Time
- igmpSnoopQueryMaxResponseTime 1.3.6.1.4.1.52.4.12.30.1.9.5 (defined in v2h124-24-mib)
expected from an endstation. If a querier has sent a number of queries defined by igmpSnoopQueryCount, but an endstation has not responded, a countdown timer is started using an initial value set by igmpSnoopQueryMaxResponseTime. If the countdown finishes, and the endstation still has not responded, then that the endstation is deemed to have left the multicast group. - bsn Global Dot11 Authentication Response Time Out
- bsnGlobalDot11AuthenticationResponseTimeOut 1.3.6.1.4.1.14179.2.3.1.2 (defined in AIRESPACE-WIRELESS-MIB)
This attribute shall specify the number of TU that a responding STA should wait for the next frame in the authentication sequence. - Cisco AON End Point Minimum Response Time
- caonEndPointMinResponseTime 1.3.6.1.4.1.9.9.646.1.1.10.1.8 (defined in CISCO-AON-STATUS-MIB)
This object indicates the minimum response time experienced by the PEP to receive a response from the end point. - Cisco AON End Point Max Response Time
- caonEndPointMaxResponseTime 1.3.6.1.4.1.9.9.646.1.1.10.1.9 (defined in CISCO-AON-STATUS-MIB)
This object indicates the maximum response time experienced by the PEP to receive a response from the end point. - Cisco AON End Point Average Response Time
- caonEndPointAvgResponseTime 1.3.6.1.4.1.9.9.646.1.1.10.1.10 (defined in CISCO-AON-STATUS-MIB)
This object indicates the average response time experienced by the PEP to receive a response from the end point. - Cisco Content Service Net Server First Payload Response Time
- ccsNetServerFirstPayloadResponseTime 1.3.6.1.4.1.9.9.597.1.1.1.1.8 (defined in CISCO-CONTENT-SERVICES-MIB)
The amount of time to wait for the first payload packet from the network server. The ciscoContentServicesNetServerResponseTimeExceeded notification is generated when the first payload response is exceeded by the network server. When the time interval is changed, the counter specified by ccsNetServerResponseTimeFailCountNotifInfo will be reset and the alarm specified by ciscoContentServicesNetServerResponseTimeExceeded will be cleared if exists. - Cisco Content Service Net Server Response Time Fail Alarm Threshold
- ccsNetServerResponseTimeFailAlarmThreshold 1.3.6.1.4.1.9.9.597.1.1.1.1.9 (defined in CISCO-CONTENT-SERVICES-MIB)
This object specifies the alarm threshold of the number of the responses specified by ccsNetServerResponseTimeFailCountNotifInfo for the first payload packet from the network server exceeds the response time ccsNetServerFirstPayloadResponseTime within the time interval (ccsAdControlAlarmUpdateTimer). When ccsAdControlNotifEnabled is set to 'true', the count is greater than the threshold and no alarm notification specified by ciscoContentServicesNetServerResponseTimeExceeded has been issued, the alarm notification will be generated and the timer will be re-started. The threshold should be greater than the clear threshold ccsNetServerResponseTimeFailClearThreshold. When the threshold is changed, the counter will be reset, the alarm will be cleared if exists, and the timer will be re-started. - Cisco Content Service Net Server Response Time Fail Clear Threshold
- ccsNetServerResponseTimeFailClearThreshold 1.3.6.1.4.1.9.9.597.1.1.1.1.10 (defined in CISCO-CONTENT-SERVICES-MIB)
This object specifies the clear threshold associated with ccsNetServerResponseTimeFailAlarmThreshold. If ccsAdControlNotifEnabled is set to 'true', the count (ccsNetServerResponseTimeFailCountNotifInfo) is equal to or lower than the threshold when the timer (ccsAdControlAlarmUpdateTimer) expires and the alarm specified by ciscoContentServicesNetServerResponseTimeExceeded exists, the clear notification specified by ciscoContentServicesNetServerResponseTimeAlarmCleared is generated. The threshold should be less than the alarm threshold specified by ccsNetServerResponseTimeFailAlarmThreshold. When the threshold is changed, the counter will be reset, the alarm will be cleared, and the timer will be re-started. - Cisco Content Service Net Server Response Time Fail Count Notification Info
- ccsNetServerResponseTimeFailCountNotifInfo 1.3.6.1.4.1.9.9.597.1.4.12 (defined in CISCO-CONTENT-SERVICES-MIB)
This object specifies the number of the response for the first payload packet from the network server exceeds the response time specified by ccsNetServerFirstPayloadResponseTime. - Cisco Dns Max Сounter Ha Server No Response Time
- cDnsMaxCntrHaSvrNoRespTime 1.3.6.1.4.1.9.9.405.1.10.3 (defined in CISCO-DNS-SERVER-MIB)
Total time in seconds, where the partner of the server was not responding. - Cisco Dns Max Сounter Ha Server Max No Response Time
- cDnsMaxCntrHaSvrMaxNoRespTime 1.3.6.1.4.1.9.9.405.1.10.4 (defined in CISCO-DNS-SERVER-MIB)
Maximum contiguous time in seconds, where the partner of the server was not responding. - Cisco Dns Max Сounter Interval Ha Server No Response Time
- cDnsMaxCntrIntHaSvrNoRespTime 1.3.6.1.4.1.9.9.405.1.11.3 (defined in CISCO-DNS-SERVER-MIB)
Total time in seconds, where the partner of the server was not responding during reporting interval. - Cisco Dns Max Сounter Interval Ha Server Max No Response Time
- cDnsMaxCntrIntHaSvrMaxNoRespTime 1.3.6.1.4.1.9.9.405.1.11.4 (defined in CISCO-DNS-SERVER-MIB)
Maximum time in seconds, where the partner of the server was not responding during reporting interval.
