With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.
cncNcdpHoldTime
Cisco Network Clock Ncdp Hold Time
1.3.6.1.4.1.9.9.121.1.1.6
The delay between the transmission of NCDP configuration PDUs. The hold time is used to limit the transmission of NCDP configuration PDUs out of an interface to a maximum of one configuration PDU per hold time interval per interface. The value of this object should normally be set to match the value of cncNcdpMessageInterval. If the value of this object is higher than the value of cncNcdpMessageInterval, NCDP configuration PDUs will end up being propagated at the rate specified by the value of this object instead. This object is only used by the NCDP protocol entity.
Back to CISCO-ATM-NETWORK-CLOCK-MIB MIB page.
IPHost Network monitor allows you to monitor cncNcdpHoldTime on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco multiplexers right now.
