The objects described here can be monitored with the IPHost Network Monitor.
You can start SNMP monitoring using free 30-day trial version of IPHost right now.
OID list for network port
- Sys Network Port Monitor Bridge Index
- a3ComSysNetworkPortMonitorBridgeIndex 1.3.6.1.4.1.43.29.4.12.2.1.1 (defined in A3COM-SWITCHING-SYSTEMS-MIB)
The index of the bridge relative to this agent where the monitored port identified by this entry is located. - Sys Network Port Monitor Analyzer Address
- a3ComSysNetworkPortMonitorAnalyzerAddress 1.3.6.1.4.1.43.29.4.12.2.1.3 (defined in A3COM-SWITCHING-SYSTEMS-MIB)
The physical address of the port where the analyzer, which is monitoring the port identified by this entry, is located. Setting the value of a non-existent instance of this object attempts to add an entry to the table. The effect of adding an entry to the table is to enable monitoring of the port by the analyzer specified. Setting the value of an existing instance of this object will switch the monitored port to the new analyzer address. - Sys Network Port Monitor Status
- a3ComSysNetworkPortMonitorStatus 1.3.6.1.4.1.43.29.4.12.2.1.4 (defined in A3COM-SWITCHING-SYSTEMS-MIB)
The status of the entry. Setting an existing instance of this object to invalid(2) attempts to remove the corresponding entry from the table. The effect of removing an entry from the table is to disable monitoring of the port. - PNNIx Map Transit Network Advertised Port Id
- pnnixMapTnsAdvertisedPortId 1.3.6.1.4.1.800.3.2.1.1.1.17.1.2 (defined in XPNNI-MIB)
The port identifier used from the advertising node to reach the given transit network. - PNNIx Route Transit Network Advertised Port Id
- pnnixRouteTnsAdvertisedPortId 1.3.6.1.4.1.800.3.2.1.1.1.19.5.1.7 (defined in XPNNI-MIB)
The port identifier used from the advertising node to reach the given transit network. - Compaq Network Interface Card If Physical Adapter Port
- cpqNicIfPhysAdapterPort 1.3.6.1.4.1.232.18.2.3.1.1.10 (defined in CPQNIC)
The port number of the interface for multi-port NICs. A port number of -1 indicates that the port could not be determined. - Network AppleTalk Net Diag Outbound Port
- nwAtNetDiagOutboundPort 1.3.6.1.4.1.52.4.2.2.2.3.4.2.12.3.2 (defined in ctron-appletalk-router-mib)
An integer representing the port through which the diagnostic test will broadcast or multicast packets. - Network Atport Zone Port
- nwAtportZonePort 1.3.6.1.4.1.52.4.2.2.2.4.1.1.1 (defined in ctron-appletalk-router-mib)
An integer representing the port to which this zone belongs. The port identified by a particular value of this object is the same port as identified by the same value of nwAtportIndex. - Network Appn Ext If Port Type
- nwAppnExtIfPortType 1.3.6.1.4.1.52.4.2.2.2.3.5.2.2.2.1.2.1.4 (defined in ctron-appn-mib)
Specifies the type of line used by the port. The value corresponds to one of the following: nonswitched(1), switched(2), or satf(3). - Network Appn Forward Link Station Port Name
- nwAppnFwdLsPortName 1.3.6.1.4.1.52.4.2.2.2.3.5.2.2.3.1.1.1.6 (defined in ctron-appn-mib)
This link station port name corresponds to the port name index into the the nwAppnExtensionTable which describes the router port on which the adjacent link station is defined. - Network DECnet IV Host Map Port Number
- nwDecIVHostMapPortNumber 1.3.6.1.4.1.52.4.2.2.2.3.3.2.6.3.1.1.6 (defined in ctron-deciv-router-mib)
The unique value for the logical port number. It's value ranges between 1 and a maximum value which is dependent on both the number of configured interfaces in the system and the number of circuits present on those interfaces which are of WAN type. - Network Ip Host Map Port Number
- nwIpHostMapPortNumber 1.3.6.1.4.1.52.4.2.2.2.3.1.2.6.3.1.1.7 (defined in ctron-ip-router-mib)
The unique value for the logical port number. It's value ranges between 1 and a maximum value which is dependent on both the number of interfaces in the system and the number of circuits present on interfaces which are of WAN type. - Network Ip Acl Port Number
- nwIpAclPortNumber 1.3.6.1.4.1.52.4.2.2.2.3.1.2.7.2.1.10 (defined in ctron-ip-router-mib)
Specifies the port number used to compare for matches on the access control list. nwIpAclPortNumber only applies if nwIpAclProtocol is equal to 4 or 5, UDP or TCP nwIpAclPortNumber ranges from 0 to 65536. The value 0 is a wildcard which matches any port. - Network Ip Redirect Port
- nwIpRedirectPort 1.3.6.1.4.1.52.4.2.2.2.3.1.2.9.1.1.1.1 (defined in ctron-ip-router-mib)
This is the primary index into the UDP redirector table, identifying the UDP port number of the packets that will be redirected. - Network Ipx Host Map Port Number
- nwIpxHostMapPortNumber 1.3.6.1.4.1.52.4.2.2.2.3.2.2.6.3.1.1.7 (defined in ctron-ipx-router-mib)
The unique value for the logical port number. It's value ranges between 1 and a maximum value which is dependent on both the number of configured interfaces in the system and the number of circuits present on those interfaces which are of WAN type. - sfps RA Topology Agent Neighbor Network Port
- sfpsRATopAgentNeighborNetworkPort 1.3.6.1.4.1.52.4.2.4.2.2.3.12.3.2.1.1.4 (defined in ctron-sfps-topology-mib)
- Enterasys Load Sharing Network Address Translation Ipv4 Config FTP Control Port
- etsysLsnatIpv4ConfigFTPCtrlPort 1.3.6.1.4.1.5624.1.2.74.1.2.1 (defined in enterasys-lsnat-mib)
This object contains the IPv4 FTP Control Port used by LSNAT. - Enterasys Load Sharing Network Address Translation Real Server Port
- etsysLsnatRealServerPort 1.3.6.1.4.1.5624.1.2.74.2.3.1.3 (defined in enterasys-lsnat-mib)
The service port used when accessing this Real server. A value of zero indicates that all ports can be used by Virtual servers accessing this Real server. - Enterasys Load Sharing Network Address Translation Binding Reverse Destination Port
- etsysLsnatBindingReverseDstPort 1.3.6.1.4.1.5624.1.2.74.2.7.1.11 (defined in enterasys-lsnat-mib)
The reverse destination port for this LSNAT binding entry. - agent Network Ds Port Number
- agentNetworkDsPortNumber 1.3.6.1.4.1.14179.1.2.3.11 (defined in AIRESPACE-SWITCHING-MIB)
The switch's distribution port number. - Cisco Network Office Switch Port Duplex Status
- cnosPortDuplexStatus 1.3.6.1.4.1.9.10.43.1.3.1.1.4 (defined in CISCO-CNO-SWITCH-MIB)
The operating duplex mode of the switched port. - Cisco Network Office Switch Port Speed Admin
- cnosPortSpeedAdmin 1.3.6.1.4.1.9.10.43.1.3.1.1.5 (defined in CISCO-CNO-SWITCH-MIB)
Set to tenMbps(1) to operate in 10Mbps speed mode. Set to oneHundredMbps(2) to operate in 100Mbps speed mode. Set to autoNegotiate(3) to allow the switch to negotiate with the other end of the connection. - Cisco Network Office Switch Port Monitoring
- cnosPortMonitoring 1.3.6.1.4.1.9.10.43.1.3.1.1.7 (defined in CISCO-CNO-SWITCH-MIB)
Set to enabled(1) to forward receive and transmit frames on this port to the port identified by cnosSysConfigMonitorPort. Set to disabled(2) to not monitor frame traffic on this port. - Cisco Network Office Switch Port Spanning Tree Protocol Port Fast Mode
- cnosPortSTPPortFastMode 1.3.6.1.4.1.9.10.43.1.3.1.1.9 (defined in CISCO-CNO-SWITCH-MIB)
This object configures the port into the Spanning Tree port-fast mode. When enabled(1), the STP can transition the port's state directly from blocking to forwarding, and vice versa, without going through the intermediate listening and learning states. This object should only be enabled for a port that is connected to a single workstation. A port that is attached to a network segment with multiple network nodes or bridges should have this object set to disabled(2) since a temporary loop may occur when port changes state. - Cisco Network Office Switch Port Vlan Member
- cnosPortVlanMember 1.3.6.1.4.1.9.10.43.1.3.1.1.10 (defined in CISCO-CNO-SWITCH-MIB)
Set the port to be a member of a specified VLAN. Set the port to all(5) to be shared among all VLANs.
