The objects described here can be monitored with the IPHost Network Monitor.
You can start SNMP monitoring using free 30-day trial version of IPHost right now.
OID list for port errors
- Sys Token Ring Port Line Errors
- a3ComSysTokenRingPortLineErrors 1.3.6.1.4.1.43.29.4.13.2.1.8 (defined in A3COM-SWITCHING-SYSTEMS-MIB)
This counter is incremented when a frame or token is copied or repeated by a station, the E bit is zero in the frame or token and one of the following conditions exists: 1) there is a non-data bit (J or K bit) between the SD and the ED of the frame or token, or 2) there is an FCS error in the frame. - Sys Token Ring Port Abort Token Ringans Errors
- a3ComSysTokenRingPortAbortTransErrors 1.3.6.1.4.1.43.29.4.13.2.1.11 (defined in A3COM-SWITCHING-SYSTEMS-MIB)
This counter is incremented when a station transmits an abort delimiter while transmitting. - a3 Com Sys Token Ring Port Abort Trans Errors
- a3ComSysTokenRingPortAbortTransErrors 1.3.6.1.4.1.43.29.4.13.2.1.11 (defined in A3COM-SWITCHING-SYSTEMS-TOKEN-RING-MIB)
This counter is incremented when a station transmits an abort delimiter while transmitting. - a3 Com Sys Token Ring Port Internal Errors
- a3ComSysTokenRingPortInternalErrors 1.3.6.1.4.1.43.29.4.13.2.1.12 (defined in A3COM-SWITCHING-SYSTEMS-TOKEN-RING-MIB)
This counter is incremented when a station recognizes an internal error. - sim Port Rx Fcs Errors
- simPortRxFcsErrs 1.3.6.1.4.1.43.1.12.3.1.1.12.5.1.1.1.9 (defined in 3comab9300)
Total received frames with bad FCS at this port since last counter reset. - rs232 Asynchronous Port Parity Errors
- rs232AsyncPortParityErrs 1.3.6.1.2.1.10.33.3.1.6 (defined in rfc1317)
Total number of characters with a parity error, input from the port since system re-initialization and while the port state was 'up' or 'test'. - rs232 Asynchronous Port Framing Errors
- rs232AsyncPortFramingErrs 1.3.6.1.2.1.10.33.3.1.7 (defined in rfc1317)
Total number of characters with a framing error, input from the port since system re-initialization and while the port state was 'up' or 'test'. - Repeater Monitor Port Alignment Errors
- rptrMonitorPortAlignmentErrors 1.3.6.1.2.1.22.2.3.1.1.6 (defined in rfc1516)
This counter is incremented by one for each frame received on this port with the FCSError and FramingError signals asserted and CollisionEvent signal deasserted and whose OctetCount is greater than or equal to minFrameSize and less than or equal to maxFrameSize (Ref: IEEE 802.3 Std, 4.4.2.1). If rptrMonitorPortAlignmentErrors is incremented then the rptrMonitorPortFCSErrors Counter shall not be incremented for the same frame. The approximate minimum time for rollover of this counter is 80 hours. - dot1d Source Route Port Duplicate Lan Id Or Tree Errors
- dot1dSrPortDupLanIdOrTreeErrors 1.3.6.1.2.1.17.3.1.1.17 (defined in rfc1525)
The number of duplicate LAN IDs or Tree errors. This helps in detection of problems in networks containing older IBM Source Routing Bridges. - rs232 Asynchronous Port Framing Errors
- rs232AsyncPortFramingErrs 1.3.6.1.2.1.10.33.3.1.7 (defined in rfc1659)
Total number of characters with a framing error, input from the port since system re-initialization and while the port state was 'up' or 'test'. - rs232 Sync Port Frame Check Errors
- rs232SyncPortFrameCheckErrs 1.3.6.1.2.1.10.33.4.1.3 (defined in rfc1659)
Total number of frames with an invalid frame check sequence, input from the port since system re-initialization and while the port state was 'up' or 'test'. - per Port Ddp Too Short Errors
- perPortDdpTooShortErrors 1.3.6.1.2.1.13.18.1.1.10 (defined in rfc1742)
The total number of input DDP datagrams on this port dropped because the received data length was less than the data length specified in the DDP header or the received data length was less than the length of the expected DDP header. - per Port Zip Zone Conflict Errors
- perPortZipZoneConflictErrors 1.3.6.1.2.1.13.18.1.1.21 (defined in rfc1742)
The number of times a conflict has been detected on this port between this entity's zone information and another entity's zone information. - sdlc Port Statistics Protocol Errors
- sdlcPortStatsProtocolErrs 1.3.6.1.2.1.41.1.1.3.1.14 (defined in rfc1747)
This object reflects the total number of times that the SDLC link stations on this port have deactivated the link as a result of having received a protocol violation from the adjacent link station. This object is initialized to zero when the port is created. - switch Port Alignment Errors
- switchPortAlignmentErrors 1.3.6.1.4.1.52.259.10.3.4.2.1.1.6 (defined in elh100-mib)
The number of valid-length frames received by the port that had alignment errors. - port Statistics FCS Errors
- portStatsFCSErrors 1.3.6.1.4.1.173.7.8.1.3.1.6 (defined in netlink-specific-mib)
A value consistently greater than zero indicates line probelms. - Repeater Port Group Packet Statistics Errors
- rptrPortGrpPktStatsErrors 1.3.6.1.4.1.52.4.1.1.1.4.2.2.1.1.5 (defined in repeater-rev4-mib)
Return this port group's total errors. - Repeater Port Packet Statistics Errors
- rptrPortPktStatsErrors 1.3.6.1.4.1.52.4.1.1.1.4.3.2.1.1.6 (defined in repeater-rev4-mib)
Get this port's total errors. - Cisco 90i Port Link Errors
- frxPortLinkErrors 1.3.6.1.4.1.1570.1.5.2.1.2 (defined in CISCO-90-MIB)
Number of signaling link reliability errors from subscriber port. A signaling reliability error is declared whenever the channel units did not receive an Annex-D link integrity poll or full status inquiry poll from the subscriber port within the required time. - Cisco 90i Port Protocol Errors
- frxPortProtErrors 1.3.6.1.4.1.1570.1.5.2.1.3 (defined in CISCO-90-MIB)
Number of signaling protocol errors from subscriber port. A signaling protocol error is declared whenever the channel units receive an Annex-D link integrity poll or full status inquiry poll with incorrect format or sequence numbers from the subscriber port. - port Errors
- portErrors 1.3.6.1.4.1.7505.1.1.15.1.8 (defined in CALISTA-DPA-MIB)
The number of centiseconds during which PBX protocol errors were detected for this port. It is normal for there to be some errors, especially during port initialization, but very large values should only be seen on disconnected ports. - Cisco BSC Port Soft Errors
- bscPortSoftErrors 1.3.6.1.4.1.9.9.36.1.1.1.1.8 (defined in CISCO-BSC-MIB)
Count of soft errors; these are errors which have been recovered. This includes CRC errors received, frames which were retransmitted for any reason (NAK received or the wrong ACK received), etc. This count is a measure of the quality of the port/line, but should be considered in relation to the amount of traffic on the port (frames or bytes sent and received). This count includes all control unit soft errors on this port, plus errors which were not for a specific control unit. - Cisco BSC Port Hard Errors
- bscPortHardErrors 1.3.6.1.4.1.9.9.36.1.1.1.1.9 (defined in CISCO-BSC-MIB)
Count of hard errors; these are errors which have not been recovered after bscPortRecoveryRetries number of retries, and therefore the connection has been terminated. These errors could be caused by a hardware error in the line or in the remote device; or possibly the bscPortRecoveryRetries value is set too low for the quality of the line. This count includes all control unit hard errors on this port, plus errors which were not for a specific control unit. - Fibre Channel Management Port Address Errors
- cfcmPortAddressErrors 1.3.6.1.4.1.9.10.999999.1.6.1.15 (defined in CISCO-FC-MGMT-MIB)
The number of frames received with unknown addressing. e.x. unknown SID or DID. the SID or DID is not known to the routing algorithm. - Fibre Channel Management Port Errors Group
- cfcmPortErrorsGroup 1.3.6.1.4.1.9.10.999999.3.2.8 (defined in CISCO-FC-MGMT-MIB)
Error statistics for Fibre Channel ports. - Cisco Fibre Channel PMT Port Other Errors
- cfcpmtPortOtherErrors 1.3.6.1.4.1.9.9.99997.1.2.1.1.18 (defined in CISCO-FC-PM-MIB)
The counter associated with the number of times an undefined error has occurred aggregating the previous valid 15-minute measurement intervals. - Cisco Fibre Channel PMC Port Address Errors
- cfcpmcPortAddressErrors 1.3.6.1.4.1.9.9.99997.1.2.2.1.15 (defined in CISCO-FC-PM-MIB)
The counter associated with the number of frames received with unknown addressing in the current 15 minute interval. - Cisco Fibre Channel PMI Port Delimiter Errors
- cfcpmiPortDelimiterErrors 1.3.6.1.4.1.9.9.99997.1.2.3.1.17 (defined in CISCO-FC-PM-MIB)
The counter associated with the number of invalid frame delimiters received at this port in a particular 15 minute interval in the past 24 hours. - ibm SE Port Arp Replies Errors
- ibmSEPortArpRepliesErrors 1.3.6.1.4.1.2.5.8.4.1.1.1.10 (defined in ibm-ibmlanex)
The number of received LE ARP Responses that were dropped by the SEB port because the SEB port originating the corresponding LE ARP Request could not be determined. - agent Inventory Stack Port Total Errors
- agentInventoryStackPortTotalErrors 1.3.6.1.4.1.4526.10.13.7.2.1.10 (defined in NETGEAR-INVENTORY-MIB)
Number of errors since boot. The counter may wrap. Ports which are in ethernet mode will return 0. - ONEACCESS Atm Port Hec Errors
- oacAtmPortHecErrors 1.3.6.1.4.1.13191.10.3.2.1.1.5.1.4 (defined in oneaccess-atm-mib)
Cells received with HEC error counter - ONEACCESS Atm Aal5 Port Rx Errors
- oacAtmAal5PortRxErrors 1.3.6.1.4.1.13191.10.3.2.1.1.6.1.6 (defined in oneaccess-atm-mib)
Total receive errors counter (CRC32 errors, length errors, RAS timeouts) - Cisco Ptp Clock Port Associate In Errors
- cPtpClockPortAssociateInErrors 1.3.6.1.4.1.9.9.760.1.2.11.1.10 (defined in CISCO-PTP-MIB)
This object specifies the input errors associated with the peer port. - Cisco Ptp Clock Port Associate Out Errors
- cPtpClockPortAssociateOutErrors 1.3.6.1.4.1.9.9.760.1.2.11.1.11 (defined in CISCO-PTP-MIB)
This object specifies the output errors associated with the peer port. - Fibre Channel Fx Port Address Id Errors
- fcFxPortAddressIdErrors 1.3.6.1.3.42.2.1.3.1.1.10 (defined in FCFABRIC-ELEMENT-MIB)
The number of address identifier errors detected by this FxPort. - swi56xx Port Rx Alignment Errors
- swi56xxPortRxAlignmentErrors 1.3.6.1.4.1.207.8.4.4.4.87.2.1.20 (defined in AT-SWITCH-MIB)
The number of frames with alignment errors received. - swi56xx Port Rx Ip In Hdr Errors
- swi56xxPortRxIpInHdrErrors 1.3.6.1.4.1.207.8.4.4.4.87.2.1.25 (defined in AT-SWITCH-MIB)
swiPortRxIpInHdrErrors
